User manual KENWOOD ESP100

[. . . ] Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. before plugging in Make sure your electricity supply is the same as the one shown on the underside of the machine. Important ­ UK only to make coffee 1 Lift the tank lid and then lift out the tank and fill with cold fresh filtered water. Alternatively lift the lid and fill the tank whilst in position on the coffeemaker. [. . . ] The OK light will flash for a couple of seconds until the pod filter holder can be removed and emptied (see Fig. Always wait a few seconds after making coffee as it will be held in place until it is safe to remove. 13 If you want to make further cups of coffee wait for the flashing OK indicator light to glow again continuously. Wait a few seconds then pull out the pod filter holder and fit a new coffee pod or change the pod filter if an alternative type of coffee is desired. Note: when making an espresso the coffee maker will make a pumping noise which will cease part way through the operation but will resume again before all the drink is dispensed. After each coffee is dispensed, excess water from the brewing process will be discharged into the drip tray. The wires in the cord are coloured as follows: Green and Yellow = Earth, Blue = Neutral, Brown = Live. Note: For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. This machine complies with European Economic Community Directive 89/336/EEC. key tank lid cup storage pod filter (3 supplied ) pod filter holder coffee outlet power on button/indicator light OK indicator light steam button/indicator light drip tray cover drip tray steam/hot water nozzle function lever water tank important When selecting the power on and steam buttons always press them firmly. 2 to produce steam to froth milk after having brewed coffee 1 Ensure that the pod filter holder with a pod holder is fitted to the coffee maker. When the steam indicator light glows continuously the unit is ready to produce steam (see Fig. 3 Place an empty jug under the steam/hot water nozzle and move the function lever to the lower steam position ( ) to remove excess water from the system. Return the function lever to the middle ( ) position and discard the water. 4 Part fill a jug with milk ­ the milk may increase up to three times in volume so select a suitably sized jug. 5 Position the jug under the steam/hot water nozzle 6 Place the nozzle into the milk and move the function lever to the lower steam position ( ). To obtain a creamier froth, rotate the jug with slow movements from the bottom upwards. 7 Once the desired temperature and froth are obtained, stop the steam by returning the lever back to the middle ( ) position. Never allow the milk to boil as this will spoil the flavour of the coffee. 8 Pour the frothed milk into the cups containing the espresso coffee to make a cappuccino. 9 Switch off the steam button in order to make further cups of coffee. The OK indicator light will flash quickly (once per 1/4 second) for a short period to indicate the high temperature (see Fig. [. . . ] 3 When the OK indicator light stops flashing and glows continuously, place a cup under the steam/hot water nozzle and move the function lever to the lower steam position ( ). Never use teabags in the pod filter. drip tray/drip tray cover Empty the drip tray regularly. 1 Wash then dry thoroughly. service and customer care If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. UK If you need help with: using your machine or servicing, spare parts or repairs (in or out of guarantee) call Kenwood customer care on 023 9239 2333. [. . . ]