User manual KENWOOD KD-291R

[. . . ] If you should lose the fuse cover, please contact your nearest KENWOOD dealer. If the plug fitted is not suitable for the power points in your home, or the cable is too short to reach ia power point, obtain an appropriate safety approved extension lead or adaptor. [. . . ] If the plug fitted is not suitable for the power points in your home, or the cable is too short to reach ia power point, obtain an appropriate safety approved extension lead or adaptor. If a new plug is to be fitted please ensure it contains a 3 amp fuse, otherwise the circuit should be protected by a 3 amp fuse iat the distribution board. Jred in ;Zccordance with the following code: BLUE BROWN ­­NEUTRAL LIVE For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your KENWOOD dealer in case of difficulty. This product is manufactured to comply with the radio interference requirements of EEC directive 82/499/EEC. May not correspond with the colour markings identifying the terminals in your plug, proceed as folllows: The wire which is coloured ILUE must be connected to the terminal which is marked by-me letter N or coloured BLACK. If the preset voltage dose not match your local voltage, set the voltage selector to 110 ­ 127 V AC. When you connect this unit to the KENWOOD MIDI system *or e resin system other than the KENWOOD MIDI system, set the (phono) EQUALIZER AMP. = m Note If the sound heard is too low when the unit is connected to PHONO jack, set the (phono) EQUALIZER AMP. When the record has finished playing When the tonearm reaches the end of the record, it will automatically return to the arm rest. Note If you move the tonearm close to the center while the turntable is rotating, thetonearm may return to the armrest. Do not resist this movement, as this may damage the automatic return mechanism, If the tonearm does not return to the armrest during initial operation, press CUT. [. . . ] Note If you move the tonearm close to the center while the turntable is rotating, thetonearm may return to the armrest. Do not resist this movement, as this may damage the automatic return mechanism, If the tonearm does not return to the armrest during initial operation, press CUT. [. . . ]