User manual KITCHENAID KSW80T0MMR INS

[. . . ] These instructions are intended for use by qualified fabricators and installers only. 2 Installation Instructions. . . · As with all metal objects, follow proper handling techniques. · Freight handling and job site exposure may have damaged the sink. This sink should be examined for damage prior to enclosure/installation. · Installation of all KitchenAidTM Undermount sinks is based on "sandwiching" the rim of the sink between the countertop and 1/2" plywood reinforcement sheet (sink support). [. . . ] Secure 1/2" plywood sheet (sink support)female to work surface using various clamps. Fasten the template (plywood) to the 1/2" plywood sheet (sink support). Using the 1-3/16" router guide bushing and the 1/2" straight cutter bit, cut opening in the 1/2" plywood sheet (sink support). Generously apply aCorning 786silicone bead around continuous the sink rim. Using the 1/4" straight cutter. 060", recess the flange of in bit, opening the sink support by . 050" to to accept sink. Liberally2"apply silicone dabs on plywood sink support at least back from the sink cut-out. (See Figure 3. ) Silicone dabs . 050" / . 060" Silicone Section Detail 1/2" plywood reinforcement sheet Section Detail Figure 3 Figure 2 4. Remove the female template and set aside. Cut out countertop IMPORTANT: All solid surfaces (such as marble and granite) must be cut by a qualified installer or fabricator. 5. Align sink to underside of countertoptopside of the a cut-out so that uniform sink edge is visible from the countertop around the periphery of the cut-out. IMPORTANT: You cannot make any adjustments after performing Step 6, following: 6. Clamp sink supportand solvent totoremove excess a and sink rim countertop. Use non-abrasive cloth silicone that has been squeezed out beyond the cut-out edge. Keep clamps on for a minimum of 24 hours before installing in cabinet. 1. Clamp 1/2" plywood female template on top surface of countertop, in desired position. This position will be determined by the relationship of the sink rim to cabinet gables, cabinet supporting members, and deck mounted fittings. 2. Cut out countertop by tracing edge of female template, using the 1-3/16" router guide bushing and the 1/2" straight cutter bit. 3. Finish cut-out edge of countertop with desired finishing techniques. 4 Use & Care Guide Do routine cleaning Use soap, warm water and sponge. To remove stubborn stains Use any cleaner acceptable for use on stainless steel. Apply evenly to the entire surface of the sink and buff to a shiny finish. Their particles may become embedded in the sink surface and cause a rusty discoloration. They trap water causing iron deposits and surface discoloration. Warranty LIFETIME LIMITED WARRANTY For the lifetime of the product from the date of purchase, when this sink is installed, operated and maintained according to instructions attached to or furnished with the product, KitchenAid will replace sinks found to be defective in materials or workmanship with an equivalent stainless steel sink supplied by KitchenAid. KitchenAid reserves the right to inspect any sink reported to be defective prior to replacement. [. . . ] Or call our Customer Interaction Center at 1-800-422-1230 from anywhere in the USA, or write: CIC Center, KitchenAid Brand Home Appliances, Customer Interaction Center, 553 Benson Road, Benton Harbor, MI 49022-2692. In the event of a warranty claim, the owner will be required to provide proof of purchase and a complete description of the problem. Keep this book and your original invoice together for future reference. You must provide proof of purchase or installation date for in-warranty service. [. . . ]