User manual KLIPSCH 28K

[. . . ] We recommend playing your 28K a minimum of 72 hours before performing any critical listening. Therefore, please note that your 28K will improve sonicly over the course of the first week. During this time, you will notice the sound from your 28K will become richer, warmer and more open. UNPACKING YOUR NEW 28K Remote Control Preamplifier Your new 28K Remote Control Preamplifier was diligently hand-crafted, thoroughly tested and carefully packed at our factory in California, USA. In the unlikely event that your 28K is damaged during shipment, be sure to save the carton as evidence for the freight carriers' inspection and call your authorized dealer immediately. [. . . ] LISTEN SELECTOR Thiscontrol is used to determine what source is being routed to the preamp outputs. Record Out Selector Thiscontrol is used to determine what source is being routed to the record outputs. iB. INPUTS line level inputs for your sources. The top row is for the left channel and the bottom row for the right channel. TAPEOUTPUTS These are fixed level outputs for use with recording devices. PREAMPOUTPUTS These are variable level outputs for use with your power amplifier. These are 11. RPC120 CONNECTOR This mini jack connector is for optional RPC120 Power Station. A/C POWERCONNECTOR the This three prong connector isfor the A/C power cable. SYSTEM SETUP AND OPERATION This section provides you with the setup procedures and functions to easily connect and operate the 28K Remote Control Preamplifier in your system. INPUTS Before inserting or removing any connectors be certain both the preamp and power amp are OFF. Using the appropriate RCA cables connect your source to the corresponding input on the rear panel. Consult you Aragon dealer for his or her recommendations on RCA cables. OUTPUTS Connect the input of your tape recorder to the tape outputs on the back panel of the preamp. Connect the input of your power amp to either preamp output connector. Two preamp outputs are provided to facilitate the use of two power amps or a subwoofer if desired. AC INPUT After you have finished with all of your input and output connections plug the female end of the provided AC line cord into the 3-pronged lEG socket on the rear panel. Plug the optional RPC120 Power Station into the AC Power Control Output on the back of your 28k. When connected, this will allow the turn-on/off of your entire audio system by simply turning on/off your 28k. The AC switching is performed externally to eliminate the additional noise associated with high current AC power in proximity to the sensitive analog circuitry. POWER I MUTE SELECTOR When the Power/Mute switch is rotated clockwise to the Power position, the LED will flash red for approximately 3 seconds (initializing) then turn green, indicating that the preamp is in operating mode. Rotating the switch clockwise with the 28k on will shut the preamplifier off and the LED will go out. With the 28k on, rotating the switch counter clockwise to the Mute mode will mute the Preamp outputs (not Record) of the 28K and the LED will turn red. [. . . ] Clockwise from the left the sequence is; CD, DIA, TUNER AUX, TAPE 2, TAPE 1. REMOTE CONTROL OPERATION This simple to operate six button remote control provides for the Power, Mute, Volume and Balance controls as listed above. The unit and LED will perform the same operations as when controlled from the front panel. Please note that when using the remote control, the 28k LED will flash green and red indicating that the remote control is communicating with the 28k preamplifier Now that you are familiar with the controls and functions of your 28K Remote Control Preamplifier, pick out your favorite music and ENJOY! [. . . ]