User manual KLIPSCH KLIPSCH

[. . . ] PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. [. . . ] As a result, the La Scala's only sonic compromise as compared to the Klipschorn is a slightly higher bass cutoff. UNPACKING & ASSEMBLY Heresy III and Cornwall III The Heresy III and Cornwall III models are large, heavy speakers. It is recommended that two people be used to unpack and install these models. Open the top carton flaps, invert the carton and pull it up and off of the speaker. The Klipschorn and La Scala II low and high frequency cabinets are shipped in two separate cartons. The Klipschorn and LaScala II high and low frequency cabinets are matched by serial number for proper acoustic performance. Please take care to match upper and lower cabinet serial numbers when assembling these loudspeakers. La Scala II and Klipschorn low frequency cabinet: After opening the top flaps of the low frequency carton, invert the carton and lift it off of the speaker cabinet. The top of the cabinet, with it's three rubber bumpers, should be facing up (See Figure 1 & 2). Klipschorn Slide the bass cabinet into the corner where it will be placed for a test fit and make note of any obstructions that interfere with a tight fit. Remove the cabinet from the corner to install the high frequency cabinet. There is a left hand and a right hand low frequency cabinet with respect to the input panel. Please contact Klipsch Technical Support at 1-800-554-7724 for connection details. La Scala The La Scala II features a self-contained, front-firing, folded bass horn to permit placement out of the corner if required. However, because this model has less bass extension than the Klipschorn®, the low frequency, acoustic reinforcement of corner placement may be optimal. The La Scala also offers full flexibility with regard to the amount of toe-in achievable for the desired stereo image. Deep bass performance may also be augmented with a high performance Klipsch subwoofer. Figure 1 Figure 2 HERITAGE LOUDSPEAKERS 2" x 4" FRAME 122cm approx. These binding posts are labeled "HF+", "HF-", "LF+" and "LF-. " Both red (+) and black (-) posts connected with wire jumpers. Leave these jumpers in place for conventional single wire connection and use either pair of posts. Cornwall III and Heresy III: These models have two pairs of binding posts located on the rear of the loudspeaker are used to connect the speaker cables coming from your amplifier and will accommodate bare wire, spade lugs of banana plugs. These binding posts are labeled "HF+", "HF-", "LF+" and "LF-. " And have both red (+) and black (-) posts connected with metal straps. Leave these straps in place for conventional single wire connection and use either pair of posts. Remove these straps for bi-wire connection (see figure 4). 98-132cm 39"-52"+ 3 /4" PLYWOOD WARRANTY--U. S. [. . . ] Corner, floor placement will deliver the highest degree of low bass reinforcement and the slant riser base helps to compensate for the Heresy's short stature. Self stick rubber pads are supplied for attachment to the bottom of the cabinet to prevent scratching of shelves and hard surfaces. CONNECTING YOUR LOUDSPEAKER Caution: Turn your amplifier off before making any connections!· Your loudspeakers are equipped with positive (Red) and negative (Black) connection terminals, on the rear or side of the cabinet. These correspond to the positive and negative terminals on the appropriate channel (left, right, center, rear, etc. ) of your amplifier. [. . . ]