User manual KLIPSCH KMSERIES

[. . . ] Experiment with a number of different placement options and control settings to find the one that best suits your particular room and taste. When choosing your subwoofer's location, keep in mind that you will need to connect the subwoofer's built-in amplifier to an AC power outlet. Controls and Optional Connections -- Powered subwoofers can be hooked up to the subwoofer output of your electronics via the RCA jack inputs on the subwoofer's rear panel. For more information on the controls mentioned in this manual and on bass management, see your dealer or visit www. [. . . ] Connect the BLACK "negative" (­) terminal of your amplifier's LEFT channel to the BLACK "negative" (­) terminal of your subwoofer's LEFT channel input ("Speaker In"). Repeat this procedure for connecting your amplifier's RIGHT channel to your subwoofer's RIGHT channel input. Take care to make sure that no bare wires from any of the connections touch any other terminals as this could cause a short and damage your equipment. Frequencies above the set level are filtered out, allowing you to blend the subwoofer's output into your main speakers. "Level" ­ The "Level" control serves as an overall volume control for the subwoofer. It is used to match the output level of the sub to your main speakers. "Phase 0/180" ­ This control is used to acoustically match the subwoofer's output to your main speakers. You want to select one of the two positions, either 0 or 180, in which your sub has more output at your listening position. "Power Off/Auto/On" ­ "OFF/AUTO/ON" - Selecting "Auto" allows the sub to turn on the audio amplification when it senses an audio input signal. It will automatically turn off the audio amplification after 20 minutes if no signal input is detected. The sub has an LED on the bottom of the front panel that indicates the status of the auto function. This Warranty is invalid if (a) the factory-applied serial number has been altered or removed from this product or (b) this product was not purchased from a KLIPSCH authorized dealer. You may call 1-800-KLIPSCH to confirm that you have an unaltered serial number and/or you purchased from a KLIPSCH authorized dealer. This Warranty does not cover cosmetic damage or damage due to misuse, abuse, negligence, acts of God, accident, commercial use or modification of, or to any part of, the product. This Warranty does not cover damage due to improper operation, maintenance or installation, or attempted repair by anyone other than KLIPSCH or a KLIPSCH dealer which is authorized to do KLIPSCH warranty work. Some states do not allow the exclusion or limitation of incidental or consequential damages or implied warranties so the above exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights, which vary from state to state. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Caution: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. Note: This mark applies only to countries within the European Union (EU) and Norway. The Warranty on this product if it is sold to a consumer outside of the United States or Canada shall comply with applicable law and shall be the sole responsibility of the distributor that supplied this product. [. . . ]