User manual KLIPSCH PROMEDIA IN-EAR

[. . . ] Care should be taken that no foreign objects or liquids fall or are spilled inside the device. The device should be serviced by an authorized service center when: · The user should not attempt to service the device beyond what is described in the operating instructions. Customers, if dealer service is not available, contact Klipsch customer service for a return authorization (RA) number before shipping. 1 has its own internal amplifier, it was designed to hook into the line out connector. [. . . ] 1 has its own internal amplifier, it was designed to hook into the line out connector. Connection to the speaker level output jack might result in poor sound quality. Connect the control pod output, which is the round multi-pin plug, into the subwoofer "Preamp Input. From the subwoofer, connect the two remaining individual speaker wires to each of the two satellites. Be sure to observe proper polarity (+/-) for the tinned wire ends that connect to the subwoofer. 2 Satellite speakers with pedestals attached 1 Control pod, attached to one satellite speaker 1 Subwoofer 1 Packet of two individual speaker connections 1 Owner's manual packed with rubber isolation feet Some soundcard and/or PC manufacturers may have software that must be adjusted separately from the Windows volume control. The two satellite speakers should be positioned on each side of your computer monitor. To wall mount, the pedestal stands may be removed by unscrewing the 1/4" 20-thread bolt, which accommodates a wide variety of wall brackets available through stereo and appliance stores. Locate the subwoofer either directly under your computer desk, or close to the satellite speakers. Do not cover up the side sub driver or front port of the enclosure and be sure to provide enough ventilation to the rear of the subwoofer. This warranty does not cover damage due to improper operation, maintenance or installation, or attempted repair by anyone other than KLIPSCH or someone authorized by KLIPSCH to do warranty work. This warranty is invalid if the factory applied serial number or date stamp has been altered or removed from this product. Some states do not allow the exclusion or limitation of incidental or consequential damages or implied warranties so the above exclusions may not apply to every customer. This warranty gives you specific legal rights, and you may have other rights which vary from State to State. The clean, simple design affords the most extreme angle adjustment, with up to 160 degrees of movement for precise speaker positioning in the horizontal plane. If you purchased this product from a retail store, please return this product to such store in its original packaging along with proof of purchase. If you purchased this product from a computer manufacturer, please contact that manufacturer. Product may only be returned to KLIPSCH after a Return Authorization number has been obtained from KLIPSCH. Returned product must be shipped, freight prepaid to KLIPSCH in either its original packaging or packaging affording an equal degree of protection along with proof of purchase. If no sound, ensure that: - Power, input, speaker cables and connectors are securely attached - Software is properly installed and functioning - Computer sound (control panel) volume is turned up and not muted - LED glowing If one or more speakers have little or no sound, ensure that: - All cables are connected properly - Connectors are fully "seated" in soundcard and speakers - Main and subwoofer level controls are properly adjusted on control pod The warranty on this product if it is sold to a consumer outside of the United States or Canada shall comply with applicable law and shall be the sole responsibility of the distributor that supplied this product. [. . . ] Product may only be returned to KLIPSCH after a Return Authorization number has been obtained from KLIPSCH. Returned product must be shipped, freight prepaid to KLIPSCH in either its original packaging or packaging affording an equal degree of protection along with proof of purchase. If no sound, ensure that: - Power, input, speaker cables and connectors are securely attached - Software is properly installed and functioning - Computer sound (control panel) volume is turned up and not muted - LED glowing If one or more speakers have little or no sound, ensure that: - All cables are connected properly - Connectors are fully "seated" in soundcard and speakers - Main and subwoofer level controls are properly adjusted on control pod The warranty on this product if it is sold to a consumer outside of the United States or Canada shall comply with applicable law and shall be the sole responsibility of the distributor that supplied this product. To obtain any applicable warranty service, please contact the dealer from which you purchased this product, or the distributor that supplied this product. [. . . ]