User manual KLIPSCH R-1650-CSM

[. . . ] USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. UNPLUG this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. [. . . ] In drop ceiling installations, typical "drop in" 2' x 4' and 2' x 2' ceiling tiles are composed of low density materials which have the potential over time to sag and vibrate audibly. To maximize the acoustic performance of your in-ceiling speakers, Klipsch recommends you replace the original mounting panel with 1/2" to 3/4" plywood or medium density fiberboard (MDF) (figure 2). CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device. Pivoting Horn (In-Wall Models) The 3000 and 5000 series feature a pivoting horn that allows the horn to be toed-in. Before the grille is installed, carefully aim the horn toward the listening area. swiveling Horn Tweeter (In-Ceiling Models) Klipsch Reference in-ceiling models (3000 and 5000 Series) feature a swiveling tweeter to aim the high frequencies. To aim sound directly at the listening area, gently adjust the horn to the desired angle before the grille is installed. Do not attempt to turn the tweeter stem while adjusting the swivel tweeter. AND CANADA ONLY Klipsch warrants to the original retail purchaser that this product is to be free from defective materials and workmanship for the life of the product, if it is properly used and maintained. If this product proves defective in either material or workmanship, Klipsch, at its option, will (a) repair the product, or (b) replace the Cut the appropriate size opening in the wall or ceiling using the template provided. If the template is not available, cutout dimensions are provided on the Klipsch website, www. If accuracy of cut cannot be achieved, you may add 1/4" to each dimension. Attach the wire to the speaker using the wire's color coding or markings as a guide to maintain proper polarity. Insert the speaker assembly into the opening and attach by tightening the four Phillips screws (figure 3). The frame's "dog" legs will swivel out and "sandwich" the wall and frame together. (Klipsch new construction brackets make this simple if used prior to drywall installation. At this point, you may paint the speaker grilles before inserting them into the speakers. Care should be taken to avoid excessive paint build-up in the grille perforations. OPERATING CONTROLS Mid-Bass and Tweeter Attenuator Switch (3000 and 5000 Series) Some models feature a Tweeter switch (3000 series) or both a Mid-Bass and a Tweeter switch (5000 series) located on the front baffle. the switch allows a setting of either 0dB (normal) or ­3dB in the respective frequency range. [. . . ] ⷠThis limited warranty does not cover cosmetic damage, including paint damage, or consequential damage to other components or premises which may result for any reason from the failure of the product. ⷠThis limited warranty is null and void for products not used in accordance with Klipsch's instructions. ⷠThis limited warranty is null and void for products with altered or missing serial numbers and for products not purchased from an authorized dealer. ⷠThis limited warranty terminates if you sell or otherwise transfer this product to another party. [. . . ]