User manual KLIPSCH REF SATELLITE

[. . . ] Center-Channel Speaker: Center the speaker directly above or below your video screen. The integral stand allows the speaker to be placed on top of the TV (or on a shelf just above or below it) or mounted on the wall (see wall mounting instructions). Ideally, the speaker's front baffle should be flush with the front of the screen. If the speaker is well above or below the ear height of seated listeners, you can improve performance by angling it slightly up or down to compensate. [. . . ] Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the bare wire through the holes. Make sure that no strands of wire are touching from one binding post to the other or to any strands from the other conductor. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damag e . Loosen the nuts on a pair of binding posts until the holes through the metal posts are exposed, then insert the pins through the holes. Make sure that there is no metal-to-metal contact between the two pins or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. Spade lugs -- Some speaker cables are terminated with U-shaped connectors called spade lugs. Loosen the nuts on a pair of binding posts and slip the spade lugs around the metal posts. Screw the nuts down finger-tight on the lugs and inspect to ensure they have remained firmly in place. Make sure that there is no metal-to-metal contact between the two lugs or binding posts. Failure to observe this precaution at either end of the connection can result in amplifier malfunction or damage. SPEAKERS TO AMPLIFIER: KEEPING IT STRAIGHT One of the most important things about hooking up your speakers is keeping them in the same polarity, or phase. If they are connected out of phase, bass and sound localization will be degraded. The easiest way to ensure that your speakers are wired in phase is to always connect the positive and negative output terminals on your amplifier or receiver to the matching input terminals on your speakers: positive ("+", color-coded red) to positive and negative ("­", colorcoded black) to negative. Figure 2 Also on the underside of the base are three keyholes that enables the stand to function as a wall mount. L o c ate the included wall mount template and bubble level and position on the wall in the desired location. Screw #8 pan head wood screws (at least two inches) long into a wood stud or dry wall anchors with the ap p r o p r i ate load rat i n g . L e ave the screw heads protruding from the wall surface approximat e ly 1/4" and adjust as needed when hanging the speaker. Remove the center cover from the speaker's base and un-snap the included hex wrench from the underside. Loosen the four hex head screws on the speaker's ball joint assembly and position the base behind the speaker, pointing up the wall. You may need to fine-tune the speaker's angle after mounting it to the wall. Remove the logo from the speaker base by compressing its split post on the underside and rotate it 180° for proper orientation. [. . . ] This Warranty gives you specific legal rights, and you may have other rights, which vary from state to state. Figure 2 La partie inférieure de la base comporte également trois encoches en trou de serrure permettant d'utiliser le pied comme support de fixation murale. (or cut along dotted line and mail) Name: Street Address: City/State/Zip: Home Phone: Work Phone: E-mail Address: Would you like to receive the latest product updates and news via e-mail?Product Purchase Model and serial number must be included to honor your warranty card. [. . . ]