User manual KLIPSCH RSW

[. . . ] 7 Speaker to bracket mounting screws 1/4-20 5mm 4mm #8 #8c #8h move rails all of the way out side rails fit snugly against speaker equal distance on both sides STEP 1 ­ Prepare the stand base. [. . . ] Thread adjustment nuts approximately half way onto the spikes, and then thread spikes into three holes on the stand base, until adjustment nuts touch the base. Use caution when handling stand base, as the isolation spikes are sharp and can scratch wooden floors. STEP 2 ­ Attach the post assembly. Turn adjustable post assembly upside down and gently shake it until inner post (d) becomes accessible. Make sure that speaker wire port is pointing away from the front of the base, which is marked with OmniMount label. If your speaker comes with a threaded insert in the back or on the bottom, use bracket (g), (h), (j), (m) or (o). If your speaker does not come with a mounting insert, you will need to use the clamping mechanism (f). [. . . ] If your speaker does not come with a mounting insert, you will need to use the clamping mechanism (f). [. . . ]