User manual KLIPSCH SWS

[. . . ] To reduce the risk of electric shock and fire, do not remove the cover or back plate of the device enclosure. The international symbol of a lightning bolt inside a triangle is intended to alert the user to uninsulated "dangerous voltage" within the device enclosure. The international symbol of an exclamation point inside a triangle is intended to alert the user to the presence of important operating, maintenance and servicing information in the manual accompanying the device. To reduce the risk of fire or electrical shock, do not expose this equipment to rain or moisture. [. . . ] Attach the cable with a GREEN miniplug at each end to the front left/right sound card output and the SWS subwoofer's FRONT L/R INPUT. Plug the cable with BLACK miniplugs into the surround (rear) sound card output (if any) and the SWS subwoofer's REAR L/R INPUT. Plug the cable with ORANGE miniplugs into the center/ subwoofer (center/bass) sound card output (if any) and the SWS subwoofer's CENTER/SUB INPUT. Your input connections to and output connections from the SWS should match. For example, if the REAR L/R output is connected, so should the REAR L/R input. But if the REAR L/R output is not connected, neither should the REAR L/R input. Klipsch ProMedia Speaker System with Subwoofer Outputs (Fig. 2) The directions in this section apply to Klipsch ProMedia multimedia speaker systems which have the SWS-link subwoofer output jacks. For earlier ProMedia models, follow the instructions in the previous section. Use an RCA audio interconnect cable (one is supplied with the SWS) to connect this input to the RCA SUBWOOFER OUTPUT (SWS-link) jack on your ProMedia speaker system. This is the only signal connection you need to make unless you are using multiple SWS subwoofers (see "Multiple Subwoofers"). 3) An SWS subwoofer can add a solid bass foundation to the sound from a TV set's built-in speakers, if the TV has a line-level audio output jack. You will need to make a single connection to the RCA (phono) INPUT jack on the SWS subwoofer's back panel. Most TV sets sold today have one (mono) or two (stereo) audio line output jacks on their back panels. A mono audio output will be a single RCA (phono) jack, usually with a black inner ring for identification. A stereo audio output will be two RCA jacks, one with a white (or occasionally black) inner ring, the other with a red inner ring. (RCA jacks with yellow inner rings are for video. ) Use an audio interconnect cable with RCA plugs at each end (one is supplied with the SWS) to connect one of these output jacks to the RCA INPUT jack on the SWS subwoofer's back panel. Even if the TV's audio output is stereo, use only one of the two jacks; this will not impair performance. If the TV has one set of audio outputs labeled "Fixed" or "Fixed Level" and another labeled "Variable" or "Variable Level, " make sure you use one of the variablelevel jacks. FIGURE 4 Home Audio System (Fig. 4) You can connect the SWS to any home audio system that has a subwoofer output or preamp outputs for its front left and right channels. Just use an audio interconnect cable with RCA plugs at each end (one is supplied with the SWS) to connect one of these output jacks to the RCA INPUT jack on the SWS subwoofer's back panel. If the system has both subwoofer and preamp output jacks, use the subwoofer output. And if the subwoofer output is on an A/V receiver or amplifier, make sure you go into its bassmanagement setup menu and set Subwoofer to "On" or "Yes. " FIGURE 3 Caution: In actual use, stacking more than three units high is not recommended. P ro M e d i a ® S u b w o o f e r S y s t e m SWS Volume Control Connection (Fig. [. . . ] AND CANADA KLIPSCH, LLC ("KLIPSCH") warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of one (1) year from the date of purchase. During the warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts. Proof of purchase in the form of a bill of sale or receipted invoice, which is evidence that this product is within the warranty period, must be presented or included to obtain warranty service. This warranty does not cover damage due to misuse, abuse, negligence, acts of God, accident, commercial use or modification of, or to any part of this product. [. . . ]