User manual KLIPSCH SYNERGY CUSTOM IC IW

[. . . ] Repeat this procedure for connecting your amplifier's RIGHT channel to your subwoofer's RIGHT channel input (refer to Figure 4). Take care to make sure that no bare wires from any of the connections touch any other terminals as this could cause a short and damage your equipment. "HIGH LEVEL OUT" ­ This passes the "HIGH LEVEL IN" signal out to your left and right speakers with frequencies below 100Hz removed. [. . . ] It accepts the LFE signal output of your digital surround electronics. "LOW PASS" (LP) CROSSOVER ­ The crossover allows the user to select the upper-frequency cutoff of the subwoofer. Frequencies above the set level are filtered out, allowing you to blend the subwoofer's output with that of your main speakers. "GAIN" ­ This control serves as an overall volume control for the subwoofer. It is used to match the output level of the subwoofer to the main speakers. "PHASE" 0/180 ­ This control is used to acoustically match the subwoofer's output to your main speakers. Select the position, either 0° or 180°, in which your subwoofer has more output at the listening position. "POWER" ON/OFF­ In the "ON" position, the subwoofer will remain "on" constantly or can turn "on" and "off" automatically when the "AUTO/ON" circuit is engaged (see "AUTO/ON"). In the "OFF" position, the subwoofer will remain "off" until the switch is manually turned back to the "ON" position. When choosing your subwoofer's location, keep in mind that you will need to connect the subwoofer's built-in amplifier to an AC power outlet. AND CANADA ONLY The Warranty below is valid only for sales to consumers in the United States or Canada. ("KLIPSCH") warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below) for a period of five (5) years from the date of purchase. During the Warranty period, KLIPSCH will repair or replace (at KLIPSCH's option) this product or any defective parts (excluding electronics and amplifiers). For products that have electronics or amplifiers, the Warranty on those parts is for a period of two (2) years from the date of purchase. To obtain Warranty service, please contact the KLIPSCH authorized dealer from which you purchased this product. Proof of purchase in the form of a bill of sale or receipted invoice, which is evidence that this product is within the Warranty period, must be presented or included to obtain Warranty service. This Warranty is invalid if (a) the factory-applied serial number has been altered or removed from this product or (b) this product was not purchased from a KLIPSCH authorized dealer. You may call ENGLISH Optimal Connections ­ Klipsch Synergy Powered subwoofers can be connected to the subwoofer output of your electronics via the RCA jack inputs ("LINE IN") on the subwoofer's rear panel (refer to Figure 3). [. . . ] You may call ENGLISH Optimal Connections ­ Klipsch Synergy Powered subwoofers can be connected to the subwoofer output of your electronics via the RCA jack inputs ("LINE IN") on the subwoofer's rear panel (refer to Figure 3). This can be in place of the conventional speaker wire connections ("HIGH LEVEL IN"). For more information on the controls mentioned in this manual and on bass management, see your dealer or visit www. klipsch. com. 1-800-KLIPSCH to confirm that you have an unaltered serial number and/or you purchased from a KLIPSCH authorized dealer. [. . . ]