User manual KOMPERNASS KH 4013 DECORATIVE, NATURAL-STONE INDOOR WATER FOUNTAIN

[. . . ] Always change all batteries at the same time and always use batteries of the same type. No liabilty is accepted by the manufacturer for damage resulting from improper manipulation of the laser and the fine adjustment devices as well as for damages resulting from non-compliance with the safety information. · · · · · · · · · 4 Intended use The appliance is intended for use in the alignment, levelling and angle-marking of domestic building modifications. It is not intended for commercial use. Items supplied Laser Spirit Level 40 cm Laser-line attachment Laser 90° angling attachment Tripod, height-adjustable from 43-120 cm Levelling plate 2 x 1, 5 V Type AAA / LR03 / Micro Transport case Operating instructions Warranty card Appliance description q Laser Spirit Level w Spirit level e Battery compartment cover with ON/OFF switch r Laser optic t Adjustment spirit level (Levelling plate) y 360° Angle scale u Adjustment screw ( Levelling plate) i Levelling plate o Crank a Fixing screw s Securing ring d Locking lever f Levelling spirit level g Tripod h Centre column with crank adjustment j Mounting base k Securing clamp l Spirit level for angle measurement ; Laser 90° deflection attachment 2) Laser-line attachment 2! [. . . ] Securing screw (Levelling plate) 5 Commissioning Inserting the batteries · Unscrew the battery compartment cover e by turning the knurled screw of the Laser Spirit Level to the left. · Insert two batteries of type AAA / LR03 / Micro as marked in the battery compartment of the Laser Spirit Level. · Close and firmly secure the battery compartment cover e. Laser Spirit Level Switch-on: Turn the ON/OFF switch Switch-off: Turn the ON/OFF switch until it engages at the rear. until it engages at the front. Tripod · Open the tripod g so wide that the securing ring s touches the rubber ring at the end of the column. · Loosen the locking lever d, release the legs of the tripod g and extend them to the desired length. To neutralise the condition of the surface on which it stands, the tripod g can be exactly aligned with the help of the integrated spirit level f and by adjusting the length of the legs. Notice: The water bubble must be located in the middle of the circular marking. · Insert the laser 90° deflection attachment ; into the laser optic r of the beforehand adjusted Laser Spirit Level. · The exactly by 90° deflected point laser produces a vertical reference level to the laser beam. 7 Line projection (Fig. 3) This measuring method is especially helpful with for example the hanging of pictures. · Insert the laser line attachment 2) into the laser optic r of the beforehand adjusted Laser Spirit Level. · A line is then projected on to the wall, with which previously determined point-markings can be connected. Caution: Due to a broader spread there is a reduction in the brightness of the laser beam. Cleaning and Care Caution!Under no circumstance may the Laser Spirit Level be submersed in water or other liquids. [. . . ] Caution: Due to a broader spread there is a reduction in the brightness of the laser beam. Cleaning and Care Caution!Under no circumstance may the Laser Spirit Level be submersed in water or other liquids. These could cause damage to the appliance, especially to the lettering. [. . . ]