User manual KUSSMAUL 091-84-GS

[. . . ] FILE: 091-84. P65 date: 06-02-99 INSTRUCTION MANUAL ENGINE IDLER MODULE PART OF A HIGH IDLE SYSTEM ENGINE IDLER MODEL #091-84-005 VOLTGAE MONITOR MODEL #091-84-004 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The High Idle System consists of a model 091-84-005 Engine Idler and a model 091-84-004 Voltage Monitor. [. . . ] Be certain that the ball chain or other coupling does not restrict throttle motion at full closed throttle or wide-open throttle. Connect solenoid valve air lines and electrical wiring as illustrated. OPERATION The High Idler receives its power from the ignition switch and functions only when the ignition switch is either "ON" or in the ACC. High Idle is automatically disabled under any of the following conditions: 1. Operator depresses the "OFF" pushbutton on the Engine Idler 2. With the transmission switch in PARK turn the ignition switch the Accessory position. Place the transmission in PARK and press the "ON" switch to turn the LED ON again. NOTE: Steps 1 thru 5 are valid only if the battery voltage is greater than 12. 5 volts. If less than 12. 5 volts, the Voltage Monitor may turn on High Idle system. Start the engine and allow it to warm up with the transmission in PARK mode. Depress the ON switch on the Engine Idler and adjust the coupling to the actuator and the stroke to obtain the desired engine RPM. Load the electrical system by turning on the headlights, area lights or other accessories. Note that when the voltage drops below 12. 5 volts, the following occur: a. [. . . ] shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its [. . . ]