User manual KUSSMAUL 091-9

[. . . ] BOOK# 091-9-3 INSTRUCTION MANUAL ® AUTO-PUMP 12VDC AIR COMPRESSOR SYSTEM MODEL #091-9 NOTE : The 091-9 Auto-Pump consists of a 12volt motor driven compressor INPUT :12 volt, 12 amp OUTPUT :100 PSI MAXIMUM 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The Auto-Pump Air Compressor system is a compact electric motor operated single cylinder air compressor designed specifically for installation on vehicles with air brakes . [. . . ] The system may be connected to any point in the vehicle's air system . CAUTION no condensate or water must be allowed to enter or accumulate in the output of the Auto Pump . Route output pressure line downward from Auto Pump to permit moisture to drain away . Use Teflon tape, or equivalent on all connections to insure no leakage of air. The recommended installation of the Auto Pump air compressor system is shown below. Connect a suitable piece of flexible tubing from the outlet port of compressor to the air tank . An optional water separator (Auto Clean 091-9G) is available to trap moisture in the air line and stop the flow of moisture back into compressor . An optional Mounting Plate 091-9H is available to reduce any vibration and noise from Auto Pump and to simplify pump mounting. NOTE: Compressor must be mounted above air tank to assure that moisture will flow away from compressor. VEHICLE WIRING INSTALLATION 1. Wire the pressure switch to the battery and a good chassis ground, use #14 AWG WIRE MINIMUM . The compressor is calibrated to cut-in at 75 PSI and cut-out at 95 PSI . 091-9 AUTO PUMP can be wired to a positive or negative system vehicle . Optional switch and fuse can be installed as shown (use 20 amp rated switch and 15 amp SLOBLO fuse). COMPRESSOR OUTPUT IS 100 PSI MAXIMUM. DO NOT EXCEED 100 PSI OR YOU WILL VOID WARRANTY. TEMPLATE AUTO PUMP 5 3/16" 3/16" DIA. HOLE 3 PLACES 1 3/4" 3 1/2" SPECIFICATION & OUTLINE AUTO PUMP Input : 12 volts D. C. [. . . ] shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. CAUTION: WATER IN THE PUMP OUTLET WILL INDUCE FAILURE WATER DAMAGE OR OPERATING AUTO PUMP OVER 100 PSI WILL VOID WARRANTY [. . . ]