User manual KUSSMAUL 091-9-1200

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual KUSSMAUL 091-9-1200. We hope that this KUSSMAUL 091-9-1200 user guide will be useful to you.


KUSSMAUL 091-9-1200 : Download the complete user guide (96 Ko)

Manual abstract: user guide KUSSMAUL 091-9-1200

Detailed instructions for use are in the User's Guide.

[. . . ] C INSTRUCTION MANUAL AUTO CHARGE 1200 PUMP PLUS AUTOMATIC BATTERY CHARGER MODEL #091-9-1200 INPUT :115 volt, 60 Hz, 10 amps OUTPUT: 40 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The AUTO CHARGE 1200 PUMP PLUS is a compact, completely automatic, single channel battery charger designed for vehicles with a single battery system. [. . . ] The output current of any charger is inherently a series of pulses whose frequency is determined by the power line frequency. Therefore there are brief intervals during which no charging current flows. During this brief interval the Auto Charge 1200 Pump Plus measures and stores the battery voltage. This battery voltage is compared to a standard and any error is detected and used to control the charger output to the desired level. There is no "trickle charge" and therefore no danger of overcharging and water boil-off. Automatic Current Limiting When batteries are severely discharged, some batteries can be overloaded due to the high charging current required. This circuit limits the output current to the rated 40 amperes when charging a deeply discharged battery or if the starter cranks the engine while charging. The current limiter thus eliminates the need for an ignition interlock circuit. Battery Charge Condition Indicator This indicator shows the charge condition of the battery in 10 levels from "LOW CHARGE" to "FULLY CHARGED". This device indicates a defective battery when a bar graph does not rise to the "FULLY CHARGED" level after an extended period of charging. NOTE: If a battery is being charged with an external load of 4 to 10 amperes across it's terminals, the bar graph may move down 1 or 2 levels. This does not indicate a defective battery. Installation Wiring Diagram NOTE INDICATOR WIRING PIN 1 OF INDICATOR MUST GO TO PIN 1 OF CHARGER, PIN 2 OF INDICATOR MUST GO TO PIN 2 OF CHARGER AND SO FORTH PLEASE CHECK CONNECTIONS AND COLOR OF WIRES BEFORE PLUGGING IN. INDICATOR AUTO CHARGE 1200 POWER REMOTE DISPLAY Auto Pump Air Compressor WHT BLK RED Note: make sure the Auto Pump is mounted ver ti ca lly. COM AUTO PUMP FUSE POSITIVE VEHICLE BATTERY USE 8 AWG or larger on Output & Gnd RED +12 VOLTS Chassis Ground BLACK -12 VOLTS Pressure Switch Chassis Ground Chassis Ground WIRE SIZE CHART CONNECTION DEFINITION WIRE SIZE IMPORTANT: WIRE SIZE IS FOR A LENGTH OF 10 FEET. [. . . ] shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE KUSSMAUL 091-9-1200




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual KUSSMAUL 091-9-1200 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.