User manual KUSSMAUL 091-9-2000

[. . . ] A INSTRUCTION MANUAL AUTO CHARGE 2000 PUMP-PLUS AIR COMPRESSOR / BATTERY CHARGER MODEL #091-9-2000 NOTE : This charger is designed for vehicles with dual batteries and negative ground. INPUT :120 volt, 50/60 Hz, 3. 5 amps OUTPUT: 18 AMPERES 1 YEAR WARRANTY ON AIR COMPRESSOR 3 YEAR WARRANTY ON CHARGER KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The AUTO CHARGE 2000 is a compact, completely automatic, dual channel battery charger designed for vehicles with two batteries. [. . . ] There is no trickle charge and therefore no danger of overcharging and water boil-off. Automatic Current Limiting & Apportionment The charger contains automatic current limiting at 15 amperes. When charging unequally charged batteries, the lower charged battery receives a higher charge rate. When the batteries are equal, the current is shared equally until they are fully charged at which time the current goes to zero. Battery Saver & Indicator A 3 ampere BATTERY SAVER is built into the charger. When connected as shown in the installation wiring diagram, loads on battery #1 such as radios and rechargeable hand lights are automatically switched to the BATTERY SAVER when power is applied to the charger. The BATTERY SAVER allows more efficient charging by removing these loads. A BATTERY SAVER overload indicator alerts the operator that the BATTERY SAVER load has exceeded 3 amperes. Reapply the load to the BATTERY SAVER No fuses are required or provided as the BATTERY SAVER contains an electronic overload interrupter. Remote Dual Battery Charge Condition Indicator This remote indicator shows the charge condition of each battery in 10 levels from "LOW CHARGE" to "FULLY CHARGED". This device indicates a defective battery when a bar graph does not rise to the "FULLY CHARGED" level after an extended period of charging. NOTE: If a battery is being charged with an external load of 1. 5 to 4 amperes across it's terminals, the bar graph may move down 1 or 2 levels. To avoid this, connect all external loads to the BATTERY SAVER terminals. Loads connected to the BATTERY SAVER will be powered either from the BATTERY SAVER power supply when the A. C. power is "ON", or they will be connected to battery #1 when the A. C. power is "OFF". Installation Wiring Diagram WIRE SIZE CHART CONNECTION ITEM DEFINITION WIRE SIZE IMPORTANT : Wire size is 12 AWG COM BAT 1 BAT 2 B. S. [. . . ] Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its [. . . ]