User manual KUSSMAUL 091-98-12

[. . . ] 11796-1221 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 CAUTION The AUTO EJECT must be connected to the starter circuit so that the solenoid is energized only while the engine is cranking. [. . . ] If the AUTO EJECT is installed where the rear mechanism can accumulate dirt, grime or water you must install a 091-18CP Rear Enclosure. FAILURE TO FOLLOW THESE CAUTION NOTES WILL VOID THE WARRANTY INSTALLATION INSTRUCTIONS 1. A minimum clearance of 4" behind the mounting panel is required as well as 3 3/4" below the center line to clear the ejection mechanism. Drill 4 mounting holes, 3/16" diameter and one, 2 1/4" clearance hole for the AUTO EJECT. Connect one terminal of the solenoid on the AUTO EJECT to the vehicle ground and the other solenoid terminal to the vehicle's starter. By providing the time delays on both application and removal of power, no arcing can occur at the connector. power must be present at the shore line connector in order to operate the Dynamic Disconnect. MODEL # 091-18CP The Enclosure is fabricated from aluminum and contains a cutout and captive fasteners to mate with the Auto EJect mounting screws. Providing protection from road dirt and damage, this unit suggested for all Auto Eject installations in which the mechanism is exposed to the elements or subject to damage. INSTALLATION RECORD & WARRANTY Date Installed Installed By Vehicle Identification Vehicle Owner WARRANTY All product of Kussmaul Electronics Company Inc. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 years from the date the equipment was shipped. [. . . ] shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. [. . . ]