User manual LA SOMMELIERE CONTEMPRO180

[. . . ] Never place the appliance close to sources of heat such as cookers or radiators, and avoid placing it in direct sunlight. The climate class is stated on the nameplate (see page 3 and page 12). Wine coolers with winter position, however, function at ambient temperatures as low as 5ºC. Climate class Optimum room temperature +10 ºC to +32 ºC +16 ºC to +32 ºC +18 ºC to +38 ºC +18 ºC to +43 ºC Before use. [. . . ] The child lock device is cancelled by pushing the “up and down” buttons simultaneously. 3 seconds “Pon” flashes in the display, and the temperature can be set. Temperature setting at the top of the appliance Temperature indication The display shows the actual temperature. The upper digits of the display indicate the temperature at the top of the appliance, and the lower digits of the display indicate the temperature at the bottom of the appliance. The temperature indicator is equipped with a built-in filter which simulates the actual temperature in the bottles. Consequently, the indicator does not react on short-term fluctuations of the air temperature Push SET1. Then the temperature at the top of the appliance can be adjusted up and down by means of the “up and down” buttons. The temperature can be adjusted from 8 to 22°C, however so that the temperature cannot be set at a lower temperature than the actual set point for the bottom temperature sensor. Then the temperature at the bottom of the appliance can be adjusted up and down by means of the “up and down” buttons. The temperature can be adjusted from 5 to 22°C, however so that the temperature cannot be set at a higher tempera- 8 GB ture than the actual set point for the upper temperature sensor. Two-zone setting for serving temperature Alarm devices There is a sub-alarm for the low-temperature sensor and an excess-alarm for the high-temperature sensor. Alarm for high temperature: beep sound + alternating display of “Hi” and actual temperature Alarm for low temperature: beep sound + alternating display of “Lo” and actual temperature The alarm temperature depends on the set points. It is activated if the temperature has been below 3°C for 10 minutes. The beep sound can be cancelled by pushing a random thermostat button. Push the on/off button to erase the display alarm, first for cancelling the alarm, then again for restarting the compressor. Typical serving temperature settings for the top and bottom sections are 16°C and 6°C respectively. With these settings, a suitable temperature gradient will be achieved in the cabinet for the storage of various types of wine distributed from top to bottom as follows: ●● heavy red wines +16 to +19°C ●● rosé and light red wines +12 to +16°C ●● white wines +10 to +12°C ●● champagne and sparkling wines +6 to +8°C It is recommended that wine be served at a temperature which is a couple of degrees lower than the desired drinking temperature as the wine will be warmed slightly when it is poured into the glass. Single-zone setting for longterm storage Light For long-term wine storage, the top and bottom sections should both be set at 12°C. With identical settings for the top and bottom sections, the controls will maintain an even temperature throughout the cabinet. However, the temperature in the room will gradually affect the temperature in the cabinet through its door and sides, creating a slight temperature gradient from top to bottom. The controls will maintain the set temperature at the bottom of the cabinet, and any deviation from the setting will therefore occur at the top. The difference will vary from 0 to 3°C, depending on the ambient temperature. [. . . ] Den elektroniske styringen har følgende funksjoner: ●● På/av-bryter ●● Lysbryter* ●● Temperaturinnstilling ●● Temperaturvisning ●● Automatisk avriming ●● Alarm for for høye og for lave temperaturer * Lyset kan enten være på konstant eller kun når døren er åpen. Der er en underalarm for den kalde temperaturføleren og en overalarm for den varme temperaturføleren. alarmen består av et lydsignal og en advarsel på displayet. Alarm for høy temperatur: lydsignal + vekslende visning av “Hi” og aktuell temperatur Alarm for lav temperatur: lydsignal + vekslende visning av “Lo” og aktuell temperatur Alarmtemperatur er avhengig av innstilte verdier. [. . . ]