User manual LA SOMMELIERE CVDE46

[. . . ] When replace the illuminating lamp, please select the lamp which comply with the rated power input of lamp according to the rating label. Shut off the power supply before replacing • • • 11 • the lamp. When disposing your appliance, please choose an authorized disposal site. Installation of Your Wine Cooler • • • This appliance is designed to be for free standing installation or built-in (fully recessed). [. . . ] Remove the lower hinge supporter with the adjusting washer from right side. Locate the glass door to the designated position making sure that the door shaft enters the door hole at the left upper corner of the glass door. Install the two screws that are used to connect the left lower hinge with the glass door and tighten them before the door is leveled. Then remove the handle from the left side and install it on the right side of the door. 13 OPERATING YOUR WINE COOLER These Wine Cooler should be placed in where the ambient temperature is between 5-35℃. If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The controls of your Wine Cooler • • • • • Indicator light illuminates to signify the cooling mode is currently in operation. € ” Button To control this appliance turn on/off ( press and hold this buttons for approximately 2 seconds). Setting the Temperature Control The Wine Cooler has two temperature zones. When you push the two buttons for the first time, the LED readout will show the previously set temperature set for that zones . € The temperature preset at the factory are: Upper zone:: 6 Lower zone: 12 • To set the temperature in the Upper zone press Set Upper button once. The temperature will decrease by every time the button is pressed until minimum temperature is reached, at which point it will then revert back to its maximum setting and start again. € To set the temperature in the Lower zone press the Set Lower button and follow the instructions above. € To view the temperature set in either zone at any time, press the corresponding “Set Upper” or “Set Lower” button, the “Set” temperature will temporarily flash in the LED display for 5 seconds. NOTE: 14 • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will not start. € When you use the Wine Cooler for the first time or restart the Wine Cooler after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. Once the Wine Cooler is running for a few hours everything will be back to normal. € • • • How to remove the Shelves To prevent damaging the door seal, ensure that the door is fully opened before pulling the shelves out. For easy access to the wine bottles, the shelves can be pulled partway out. Pull the shelf forward until the notches in the sides of the shelf align with the pegs in the sides of the cabinet. [. . . ] When temperature is higher than 23 , it will have “Beep” sound, and “HI” will show in display, this is for high temperature alarm. You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. The rattling noise may come from the flow of the refrigerant, which is normal. [. . . ]