User manual LA SOMMELIERE TR2V120

[. . . ] € When disposing your appliance, please choose an authorized disposal site. Installation of Your Wine cooler • This appliance is designed to be for free standing installation only. € Place your Wine cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine cooler, adjust the front leveling leg at the bottom of the Wine cooler. [. . . ] € ” Button To control this appliance turn on/off ( press and hold this buttons for approximately 2 seconds). Setting the Temperature Control The Wine Cooler has two temperature zones. When you push the two buttons for the first time, the LED readout will show the previously set temperature set for that zones . € The temperature preset at the factory are: Upper zone:: 6 Lower zone: 12 • To set the temperature in the Upper zone press Set Upper button once. The temperature will decrease by every time the button is pressed until minimum temperature is reached, at which point it will then revert back to its maximum setting and start again. € To set the temperature in the Lower zone press the Set Lower button and follow the instructions above. € To view the temperature set in either zone at any time, press the corresponding “Set Upper” or “Set Lower” button, the “Set” temperature will temporarily flash in the LED display for 5 seconds. 12 NOTE: • If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine cooler will not start. € When you use the Wine cooler for the first time or restart the Wine cooler after having been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. Once the Wine cooler is running for a few hours everything will be back to normal. The keys are located inside the plastic bag that contains the User’s Guide. Insert the key into the lock and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making sure metal pin is engaged completely. Interior Light You can turn the interior light ON or OFF by pushing the button marked with the “bulb” symbol . CARE AND MAINTENANCE Replacing Your LED Light NOTE: You must cut off electrical power avoid tip-and-run hurt. Please remove 2 fixed screws of the top shelf by Philips screwdriver and take out the shelf. ) Please take out lock screw 2 by Philips screwdriver first, then push the light cover to left, you can take out it when light cover set out limited location. 13 Cleaning Your Wine cooler • Turn off the power, unplug the appliance, and remove all items including shelves and rack. € Wash the inside surfaces with a warm water and baking soda solution. [. . . ] When temperature is higher than 23 , it will have “Beep” sound, and “HI” will show in display, this is for high temperature alarm. You can solve many common Wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. The rattling noise may come from the flow of the refrigerant, which is normal. [. . . ]