User manual LA SOMMELIERE TR3V180

[. . . ] Installation of Your Wine Cooler • This appliance is designed to be for free standing installation or built-in (fully recessed) (Refer to sticker location the back of this appliance). € Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler. 9 • • • Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc. [. . . ] In the event of a power interruption, all previous temperature settings are automatically erased and each compartment will default to a preset temperature setting of: 7° for upper compa rtment and middle compartment. C • Set the desired cooling temperature by pressing the buttons adjacent to the “Set Upper/Set Middle” program. Each depression of the buttons will scroll through the available temperature settings (for each compartment) in increments of 1 degree. The temperature selected will flash in the LED display for approximately 5 seconds, then revert back to display the temperature of the internal cabinet Upper compartment::The temperature setting can be adjusted from 5° to 18° C C. Middle compartment: The temperature setting can be adjusted from 5° t o 12° C C. € To view the “Set” temperature (anytime) press and hold the corresponding button, the “Set” temperature will temporarily “flash” in the LED display for 5 seconds. € 12 The controls of your Wine cooler (the Lower zone) C UP DOWN RUN DISPLAY • • • “UP” Button Used to raise(warm) the temperature in 1 . Setting the Temperature Control • To set the temperature: Connect the power cord to a properly grounded outlet. In the event of a power interruption, all previous temperature settings are automatically erased and it will default to a preset temperature setting of: 12℃. Set the desired cooling temperature by pressing the buttons adjacent to the “UP/DOWN” program. Each depression of the buttons will scroll through the available temperature settings in increments of 1 degree. The temperature selected will flash in the LED display for approximately 5 seconds, then revert back to display the temperature of the internal cabinet The temperature setting can be adjusted from 12 to 18 Shelves To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. For easy access to the storage content, you must pull the shelves approximately 1/2 out of the rail compartment, however this unit was designed with a plastic post on each sides of the shelf tracks to prevent bottles from falling. When removing the shelf out of the inner rail, make sure to remove all items first. Then move the shelf to the position where the notch of shelf is exactly under the plastic post and lift the shelf. In order to replace the shelf, repeat steps described above in reverse. € • • • • Note If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will not start. When you use the wine cooler for the first time or restart the wine cooler after having been shut 13 off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the LED readout. Once the wine cooler is running for a few hours everything will be back to normal. The keys are located inside the plastic bag that contains the User’s Guide. Insert the key into the lock and turn it counterclockwise to unlock the door. [. . . ] Energy Saving Tips • The Wine Cooler should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight. You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. The rattling noise may come from the flow of the refrigerant, which is normal. [. . . ]