User manual LG GH20

[. . . ] · FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. · This Super Multi DVD Rewriter is for use only with UL listed personal computers that have installation instructions detailing user-installation of card cage accessory. i This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 89/336/EEC, 93/68/EEC and 2006/95/EC. CAUTION : CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. ADVARSEL : KLASSE 3B SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING. ADVARSEL : KLASSE 3B SYNLING OG USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPENS. [. . . ] * For DVD±R 20x support media: Mitsubishi Kagaku Media, That's, Maxell (MID: MAXELL 003, MXL RG04) are recommended. * Upon the media condition or some of user's environment the maximum speed sometimes could not be guaranteed. 2 * Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*. These unreadable discs may need to be read using the CD-R/RW drive they were created with The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than Multi-read compatible (UDF compatible) CD-ROMs Multiread compatible (UDF compatible) CD-ROMs are: 1. particularly those including Video playback) may require a considerably increased specification PC to give acceptable results. While this Super Multi DVD Rewriter can read DVD-video discs, decoding them to display on your pc's monitor requires separate MPEG decoding that is done by separate hardware (either an MPEG decoder card or MPEG decoding done by your video card), or separate software that you install to do MPEG decoding. For further details, refer to the documentation that comes with MPEG software. Location and Function of Controls Front Panel Rear Panel 4 1 23 12 1. Drive activity indicators The LED used to indicate the operation of Super Multi DVD Rewriter. 1. SATA Data Connector (7 pin) 3 Installing the Drive Before installing the drive, please note the following points. You will need the following: · A screw driver of a suitable size to fit the securing screws for the drive unit. · The manual for the computer, so you can find the mounting positions for the SATA cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets. Discharge any static electricity on your person by touching the computer covers, etc. Removing the Computer Cover Make sure all peripheral devices of the computer and the computer itself are turned off, and then remove the cover. Refer to the manual for the computer for details about removing the cover. NOTE : There may be sharp edges inside the computer so take care to avoid injury. Mounting the Drive 1. If there is not enough space behind the drive, connect the SATA and other cables before securing the drive. READ WRITE READ WRITE NOTE : This is a general installation guide. If your PC hardware appears different, please consult your hardware manual for installing peripheral devices. 4 PC Connection The Super Multi DVD Rewriter connects to the motherboard of the host computer using a SATA interface cable. Connecting the SATA Power Cable Connect the power cable so the projection of the cable connector side to come to the left side. NOTE : Improper connection may damage the drive and void the warranty. Generally, the power connector can only fit one way. Red Connect to the power connector of the PC. Connecting the SATA Data Cable Connect the data cable. [. . . ] Use of worn, damaged, or non-standard CD-ROM discs can adversely affect the drive and cause the disc to shatter or crush while in use. Disc crush can only occur when you use a damaged CD-ROM disc in the drive. It is an extremely rare occurrence, but there are steps which can be taken to prevent it. Take care not to use worn, cracked, damaged, warped or poor quality CD-ROMs, as this may cause damage to your drive. [. . . ]