User manual LG LD-12AW2

[. . . ] These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. · A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this product in the end user. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Port & Encryption > Web port: The default HTTP port number (80) can be changed to any port within the range 1025 to 65535. Network settings Basic Notes: · · 32 Operation and settings > > RTSP port: Check RTSP port and the default port is 554. Note: The RTSP port number should not be same with the web port number. RTP stream RTP (Real-time Transport Protocol) is an internet protocol that allows programs to manage the real-time transmission of multimedia data, via unicast or multicast. TTL > ARP Ping > Enable ARP Ping to configure IP address: Check to enable ARP ping. · Save: Click this button to confirm the settings. 33 Operation and settings Master / Slave > RTP unicast: When enabled the transmission of the data to the specified equipment happens on a network specifying a single address. > RTP multicast: When enabled it reduces the transmission load on the camera by making the computer of the same segment network receive the same transmission data. When multicast option is checked then select Video Port number, Audio Port number and Data port number. Video RTP port: Specify the video transmission port number used for the multicast streaming. It is initially set to 8888 and you can edit this between 1025 and 65534. Audio RTP port: Specify the audio port number used for the multicast streaming. It is initially set to 7777 and you can edit this between 1025 and 65534. Data RTP port: Specify the VA data port number used for the multicast streaming. To confirm the password, retype the password that you typed in the Password box. Select the authority drop down list to provide the access rights to each user and then click the [Save] to confirm your selection. Administrator: Allows you to operate setup menus and to view live images. Power user: Use of the limited functions of the system (The Configuration menu is not allowed. A power user can use the Live View, PTZ control, OSD control and audio functions. Allows to view live images only. 4. User list > Add the User You can register a new user with various access rights. Enter the new User ID and Password. 38 Operation and settings Custom user: The user can login and view the live stream image only when the "Enable anonymous login" option is checked to enable it. Anonymous > Enable anonymous login Check the box to enable anonymous user login - allows the user access for only viewing the live stream image. Maximum RTP stream connection > Maximum number of simultaneous stream connection: Set this number to limit the number of simultaneous stream connections. The connections depend on the stream configuration as shown in the following Maximum RTP stream connection by stream configuration. Note: Remember the password. > Edit the registered user You can change the password or authority. [. . . ] If POE is used check if the power is got by the network camera when connected to it. · · · Login Password lost · Reset the camera by pressing the Reset button for more than 3 seconds to restore default settings. · 61 Troubleshooting · · If video images appear white and black adjust the settings in the OSD to get back the colorful image. Select the Night mode if the network camera is connected at a place where surrounding light is less or dark. If we obtain lower frame rate than set we need to check from the system administrator for sufficient bandwidth available or reduce the number of applications running on the client computer. If the client PC's are unable to access the multicast stream, check with the system administrator for the use of a valid multicast address or check if the router is supporting multicasting. [. . . ]