User manual LG LST-255T

[. . . ] User Guide Model: LST-255 CDMA Fixed Wireless Terminal Please read this manual carefully before operating your set. Retain it for future reference. LGE CDMA Fixed Wireless Terminal LST-255 REVISED HISTORY DATE 2005. 01 ISSUE 1. 0 CONTENTS OF CHANGES Initial Release REMARK Please read this manual before you use this product. LGE reserves the right to make changes in technical and product specifications without prior notice. 3 Table of Contents 1 Before You Start Safety Instruction Optimal Phone Performance Care and Service Safety Information 7 7 7 8 9 2 Introduction Component List Front, Side and Rear View of the Terminal 3 LEDs Indicators Installation Installation Steps 12 13 14 16 17 20 3 Basic Operation Power On Placing a call Receiving a call Ending a call Warning Tone after Remote Disconnect Emergency Call Power Off 21 21 21 22 22 22 22 23 4 System Features Hook flash ROH (Receiver Off Hook) System Features Applications 24 24 24 24 26 5 Table of Contents 5 Programming Speed Dial Emergency Call Hot Line Alarm Volume Level Outgoing Call Lock G3 FAX/DATA Mode Setting Restrict Call Mode Setting Before You Start Safety Instruction WARNING/CAUTION To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. IMPORTANT Before installing or operating this product read this information. 27 27 29 30 31 32 32 33 35 Optimal Phone Performance 6 7 Troubleshooting General Information LST-255 37 38 38 Do not operate your product when holding the antenna, or when someone is within four inches (ten centimeters) of the antenna. [. . . ] Pick up the handset and begin talking. Basic Operation Power Off When you need not to use terminal anymore, you should do power off before removing AC/DC adapter cable. Ending a call When you have completed the call, place the handset back on telephone. Also you can hook flash more than about 1 second to end a call and place a new call without hanging up the handset. Execute the Power Off 1. Turn off backup battery switch and remove AC/DC power adapter cable. Warning Tone after Remote Disconnect A warning tone may be heard in the telephone after a remote party hangs up from a call, allowing another call to be initiated after hook-flash. Emergency Call When emergency call number is connected once, it will not be terminated unless the called party disconnects the call (Emergency Call Hold Service). Therefore even caller hangs up the telephone, the line will be still connected, so if the caller picks up the telephone again, he can continue talking. As long as your telephone is registered on a system, you can place a call to emergency number even if your telephone is locked or restricted. Please check the available emergency call number with your service provider. 22 23 System Features Hook flash When the terminal receives a hook-flash from the connected telephone device, it will automatically allow: 1. For producing dial tone again after a phone number has been dialed without connection. The use of special cellular services which may be available in your cellular service area. Note: - Hook-flash is accomplished in a call through either pressing the dedicated hook-flash key which is available on some phones or through a rapid single press of the hang-up mechanism upon which the handset rests when the phone is hung up. System Features Call Waiting - You can receive another incoming call during a call. In this case, you will hear beep tone and then you can connect the second call holding the first call by entering a code required by cellular service provider. Your cellular service provider may require hook-flash (a quick, simulated hang up ) to answer the waiting call. Other providers may require entering the codes involving digits 1-9, *, and # to answer a waiting call. Three-way Conference Calls - For three-way conference calls, a hook-flash transmits the SEND command. Please contact your cellular service provider for more information on using this service. Example Dial the first number and wait until connected: When connected, give hook-flash and dial the second number and give one more hook-flash to be connected: When the second call is connected, give hook flash to complete a 3-way conference call. ROH (Receiver Off Hook) If the telephone equipment remains off-hook , meaning that the handset is left off of its cradle as it would be when you hang up, with no dialing activity for about 60 seconds, a ROH tone emits from the receiver for a period of 60 seconds. After ROH tone, Line Lock Out Tone emits from receiver for a period of 60 seconds. This feature may be different or not by country specification. Voice mail - Use voice mail service in the same manner as you would on a regular telephone. If you have a new voice-mail message, the WLL-terminal transmits a special(4sec On / 1sec Off default) and Mode LED is blinking (0. 5sec On / 0. 5sec Off). Please contact your cellular service provider for more information on using Voice Mail or to change Voice-Mail Ring pattern. Caller ID - LST-255 can support caller ID service if you have a telephone with Caller ID feature. Please contact your cellular service provider for more information on using this service. System Features Many cellular systems offer special services such as call waiting, call forwarding, etc. There are certain dialing sequences to be earned, which vary from service provider to service provider. The service provider will provide the dialing instructions for your system. Call Forwarding - An incoming call can be delivered to another telephone number programmed. [. . . ] If you want to use the LST-255 only for G3 FAX sending or receiving other than the voice call, then keep the terminal in G3 FAX Mode enabled state. Set Restrict Call Level 1. Press # + # + 8 + continuously to enter Restrict Call programming mode. 1 - No restriction 2 - restriction 3 - Emergency only (All excepting emergency are restricted. ) 4 - Clear restrict table 4. Press * to save. Note4: If G3 FAX mode is enabled, You cannot set Data mode(USB) and then you should disable G3 FAX mode. [. . . ]