User manual LG LWG07

[. . . ] Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. Make sure that the unit is correctly ventilated at all times: Do not place clothing or other materials over it. [. . . ] Result: You can control all the functions your air conditioning unit directly from your seat, using the remote control. 3 E-7 DB98-22420A-1. indd 7 2006-5-31 16:31:28 Cooling Your Room Remote Control Control Panel You must select the Cool mode if you wish to lower the temperature in your room. You can also set the fan speed. If necessary, press the Result: (On/Off) button. The operating mode indicator (COOL, FAN or HEAT) on the unit comes on. The air conditioner starts up in the mode selected when the unit was last used. The unit beeps twice. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up aotomatically after about three minutes. If the COOL indicator is not lit up on the unit: Press the button on the remote control or Press the MODE button on the unit one or more times until the COOL indicator lights up Result: The unit beeps each time you press MODE. The air conditioner starts up in Cool mode. You can change modes at any time. 3 To adjust the temperature, press the To adjust the temperature, press the or or button on the remote button on the unit one control one or more times until the required temperature is displayed. - The temperature is adjusted by °C and displayed on the control panel - The unit beeps The air conditioner starts cooling if the room temperature is higher than the selected temperature. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Press the button on the remote control. or Press the on the unit until the indicator lights up Each time you press a button, the unit beeps. 4 To set the fan speed to. . . High Med Low Result: 5 E-8 To control the direction of the air flow, refer to page . DB98-22420A-1. indd 8 2006-5-31 16:31:29 Heating Your Room Remote Control Control Panel ENGLISH 16:31:30 You must select the Heat mode if you wish to heat your room to a specific temperature. You can also set the fan speed. If necessary, press the Result: (On/Off) button. The operating mode indicator (COOL, FAN or HEAT) on the unit comes on. The air conditioner starts up in the mode selected when the unit was last used. Make sure that you have selected either COOL or HEAT mode. Remote Control Control Panel Press the or Press the Result: button on the remote control button on the unit until the SLEEP indicator lights up. The "SLEEP" passes through the control panel for about 5 seconds and the" "will be dispalyed. The remaining time is displayed and decreased by hour automatically to indicate the remaining time. The air conditioner will be controlled as illustration below. Cooling When the temperature has been increased by °C(after hour), it is maintained for 7 hours. Set TEMP. 1hr 8hr Start time Stop time Heating The temperature is decreased by °C after hour. When it has been decreased by °C (after hour), the temperature is maintained for 6 hours. To Cancel the Sleep Timer To cancel the timer, press: on the remote control. The air conditioner operates in the mode selected last. E-4 DB98-22420A-1. indd 14 2006-5-31 16:31:35 Operating Recommendations ENGLISH E-5 2006-5-31 16:31:35 Here air a few recommendations that you should follow when using your air conditioner. Topic Heating performances Recommendation The heat pump inside the air conditioner absorbs heat from outside air and brings it indoors. If the temperature of the outside air drops, the air conditioner will heat less. If you find that the room is not warm enough, use an additional heating appliance. The air conditioner circulates warm air to heat your room;as a result, some time will be required after starting the air conditioner to warm the entire room. If necessarty, set the air conditioner going a short time before you wish to use the room. When outside temperatures are low and humidity is high, frost may form in the unit's condensor when heating with your air conditioner. [. . . ] Check that the operating mode indicator (COOL, FAN or HEAT) on the unit is lit up; if necessary press (On/Off) on the remote control or unit. The air conditioner does not operate with the remote control Check that there are no obstacles between you and the unit. Check that you are close enough to the unit (seven metres / yards or less). No beep is heard when you press (On/Off) on the remote control Check that you are pointing the remote control at the remote control sensor on the unit. [. . . ]