User manual LG WD-80160NP

[. . . ] An improper ground may cause electric shock or equipment damage. Do not excessively bend the plug and wire nor place heavy objects upon them, which could cause damage. This may cause an electric shock or fire. Disconnect the plug from the outlet during storms or lightening or if it is not used for a long period of time. Failure to do so may cause an electric shock or fire. Do not connect too many extension cords or plugs to an outlet. This may cause a fire. Installation Do not cover the vents on the monitor cabinet. [. . . ] Settings Control is available only for the displays for which the power status is ON. Multiple Display Control (MDC) 9. Click Settings of the main icons and the Settings Control screen appears. Info Grid shows some basic information necessary to Settings Control. 3) Panning - Moves the position of the magnified image on the screen either vertically or horizontally. Settings Control is available only for the displays for which the power status is ON. 10. Click Diagnostics of the main icons and the Settings Control screen appears. 1) SET ID - Shows the ID of the currently connected display. 3) Lamp Time - Shows the LCD Lamp On time of the currently connected display. Multiple Display Control (MDC) 11. The display you wish to control does not appear on the Power Control Info Grid - Check the connection of RS232C. (Check if it is properly connected to the Com1 port) - Check the displays to see if any of the other displays connected have the same ID. If more than one displays have the same ID, those displays are not properly detected by the program due to data conflict. (Adjust using the Display menu) Note : A Display Set ID must be a value between 1 and 10. If the value is out of the range, the MDC system cannot control the display. PIP button Every time you push the button, the PIP window's signal source changes. PIP Size button Press to make the PIP window PIP 1, PIP 2, Double Screen 1, Double Screen 2. Display button Displays the resolution, frequency and input signal settings in the center of the screen. Menu button When screen adjustment menu is off: Use this button to open the OSD and activate a highlighted menu item. Exit button On the User Controls screen, press to return to the previous menu screen or to exit the current screen. Location button Moves the position of the PIP window on the screen. OSD Functions Characters and icons become highlighted in blue during adjustment for each menu. PC Control For detailed information on Screen Adjustment in the PC mode, refer to PC mode Screen Adjustment Animation Clips. Brightness Adjust Brightness. 1) Image Lock Image Lock is used to fine tune and get the best image by removing noises that creates unstable images with jitters and shimmers. If satisfactory results are not obtained using the Fine adjustment, use the Coarse adjustment and then use Fine again. If the noise persists even after Fine tuning, repeat it after adjusting the frequency (clock speed). · Reset : Image lock and position parameters are replaced with the factory default values. [. . . ] Before making the connection, make sure the voltage rating of the computer convenience outlet is the same as the monitor and that the ampere rating of the computer convenience outlet is equal to or exceeds the monitor voltage rating. For 120 Volt applications, use only UL Listed detachable power cord with NEMA configuration 5-15P type (parallel blades) plug cap. For 240 Volt applications use only UL Listed Detachable power supply cord with NEMA configuration 6-15P type (tandem blades) plug cap. IC Compliance Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations of ICES-003. Cet appareil Numérique de classe B respecte toutes les exigences du Règlemont NMB-03 sur les équipements produisant des interférences au Canada. Regulatory MPR II Compliance This monitor complies with SWEDAC(MPR II) recommendations for reduced electric and magnetic fields. European Notice (Europe only) Products with the CE marking comply with the EMC Directive(89/336/EEC), (92/31/EEC), (93/68/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. [. . . ]