User manual LINE 6 TBP12

[. . . ] Warning: Changes or modifications not expressly approved in writing by Line 6 may void the users authority to operate this equipment. RF Exposure Statement: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Prolonged listening at high volume levels may cause irreparable hearing loss and/or damage. Battery LED - Blue LED = full, solid red LED = Low, Flashing red LED = Very Low / Change batteries. 3 MUTE OFF/ON 1 Audio LED - Green LED = Audio Signal, Red LED = Signal clip 5. LCD Display - Whenever a button is first pushed, the LCD backlight will awaken by glowing. In Main Mode your display will appear similar to the illustration below. FCC ID: UOB916TBP12 IC: 6768A-916TBP12 N222 6 5 008WWA090153 Pat. ON/OFF Switch - Slide the switch to turn the transmitter on or off. 2. Mini-XLR Input - Plug the supplied Mini XLR connector from the microphone here. Other Mini-XLR equipped microphones designed for wireless mic use may commonly be substituted. Attaching and positioning the mic: Use the mic clip to attach the lavalier mic to clothing taking care to point the microphone towards the intended sound source. Avoid fixing mic to where mechanical noise can be generated such as zippers, inside pockets, etc. BATT AUDIO 2 transmitter is set to lockout mode. When locked, the power cannot be turned off and editing is not allowed. The numeric clock at the bottom of LCD displays the amount of remaining operation time of batteries at current power level in hours and minutes. NOTE: The battery data may be invalid for the first few minutes of operation. Remove the center CHAN 1 through CHAN 12 will be displayed at the top depending on the current channel your XD-V70 is set to transmit on. The LOCK icon is lit only if the mounting screw to reposition or remove belt clip as necessary. Avoid placing cell phone near beltpack or mic. LcD setup pages Setup Page 1 - Channel Select Setup Page 3 - Name Select In order for your XD-V70 to transmit properly to your receiver both devices must be set to the same channel. To change the channel your XD-V70 is transmitting on, Hold SELECT for 2 seconds to enter setup page 1. The current channel number is displayed as 1 to 12 on the right side of the numeric display. The actual change of transmission channel will not occur until returning to the main page, by holding the SELECT button for 2 seconds (to exit Setup mode), or not pressing any button for 15 seconds (Setup page timeout). From the setup page 2, press SELECT once to access setup page 4. Press VALUE briefly to switch between name display being On or OFF, as displayed on the right most digits of the numeric display. This parameter determines if the Main page will show the channel number (NAME OFF), or a custom name (NAME on). The default setting is OFF. Setup Page 4 - Set Name Setup Page 2 - Power Select When Setup Page 3 is set to NAME On your LCD main page will read TBP12. [. . . ] This will enter the unit into lockout mode and prevent the front panel controls from being able to mute, change any settings or shut the XD-V70 off accidentally. If either the POWER or SETUP buttons are pressed while in LOCK mode the LCD will flash LOCKED across the screen. VALUE and SELECT simultaneously for 2 seconds. Once unlocked, press and hold the POWER button for 2 seconds. Make certain that XD-V70 and receiver are receiving sufficient power. Check the battery status indicator on the transmitter and replace if necessary. [. . . ]