User manual LINE 6 XD-V30 REV B

[. . . ] Warning: Changes or modifications not expressly approved in writing by Line 6 may void the users authority to operate this equipment. RF Exposure Statement: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. WARNING: To reduce the risk of fire or electric shock do not expose this apparatus to rain or moisture. The appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Connect only to AC power outlets rated: 100/120V 220/240V 50/60Hz (depending on the voltage range of the included power supply). · · · · · · · · · · Prolonged listening at high volume levels may cause irreparable hearing loss and/or damage. Always be sure to practice "safe listening. " · Service is required when the apparatus has been damaged in any way, such as: · power-supply cord or plug is damaged. · liquid has been spilled or objects have fallen into the apparatus. · the unit does not operate normally or changes in performance in a significant way. RXT06 ReceiveR OpeRaTiOn 1. Channel Select - Rotate the knob to select a receiver channel. For the system to operate both RXT06 and transmitter (THH06 or TBP06) must be set to the same channel. · 3 Green = Full charge · 2 Green = Excellent charge · 1 Green = OK charge · 1 Red = Low charge · Flashing Red = Very low charge 2. trans status audio power Battery Level Indicators XD- 1 CHANNEL 4 5 2. 4GHz DIGITAL WIRELESS SYSTEM 2 3 3. Transmitter Signal Level Indicators UNBALANCED OUT BAL OUT RXT06 RECEIVER + · 3 Green = Data excellent · 2 Green = Data OK, may have some interference · 1 Green = Data minimal, may have significant interference · No LED = No data, no interference · 1 Red = No data, some interference · 2 Red = No data, more interference · 3 Red = No data, high interference · 4. Power LED - Blue = Power On Unbalanced Output - Use a standard 1/4" cable to send audio output 9Vdc 200mA 6 7 8 6. to an unbalanced mic level connection when an XLR balanced connection is unavailable. 8. Balanced Output - (Prefered) Use a standard XLR cable to connect to Power Supply - To turn on the receiver, plug the Line 6 DC-1g power supply into the receiver's 9V DC input jack. THH06 MicROpHOne OpeRaTiOn CHANNEL SELECT Using the Lock feature 1. Press briefly to select a Channel from 1 to 6. Chanel Select - Set THH06 Microphone to the same channel as the Chanel LEDs - Illuminates blue to show the current active channel THH06 is transmitting on. Channel 6 LED will illuminate red when battery life is low and blink red when very low (change batteries). The LOCK switch is located behind the battery compartment indicated in the illustration above. [. . . ] The inside of the battery compartment door indicates the correct battery direction. For best results use only non-rechargeable alkaline batteries. 123456 6 RegisTeR and geT FRee sTuFF 4 CHANNEL input Included with the XD-V30 is a handy, postage-paid card for you to send back to us to register your purchase. It is very important you either fill that registration card out right now and send it to us in the mail, or register online at www. line6. com/register. That gets you all set up for warranty service in case you should ever have a warranty issue with your product. 5 1. [. . . ]