User manual LYNX 4VS743BD

[. . . ] 9000 251 097 (8703) en Index 4 6 7 8 9 10 11 14 16 Overview of programmes . . en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Warning For safety reasons, if the appliance is not fitted in a recess, thereby making a side wall accessible, the door hinge area should be covered at the side. (Risk of injury) Covers are available as optional accessories from customer services or specialist stores. Installation Install and connect the appliance according to the installation and assembly instructions. [. . . ] Note If you use the detergent and rinse aid separately or switch from combined detergents to standard cleaning products, ensure that the rinse aid refill indicator has been switched on and the water softening system has been set to the correct water hardness. 17 en Overview of programmes The max. The corresponding programmes for your appliance can be found on the fascia. Soups, soufflés, potatoes, pastries, rice, eggs, fried food Mixed Delicate Mixed Soups, potatoes, pastries, rice, eggs, fried food Coffee, cake, milk, sausage, cold drinks, salads Amount of food remnants State of food remnant Wash programme Very adhesive Intensive 70_ Large Medium Auto 55_-65_ Eco 50_ Little Very little Lightly Adhesive Rinse off if the dishes have been stacked for several days in the dishwash er prior to washing. Gentle 40_ Quick 45_ Prerinse Programmesequence The programme sequence is optimised and adjusted according to the degree of soiling on the utensils. Prerinse 40_ Prerinse Clean 50_ Intermediate rinse Clean 65_ Dry Prerinse Clean 40_ Intermediate rinse Clean 55_ Dry Clean 45_ Intermediate rinse Clean 55_ Prerinse Clean 70_ Intermediate rinse Clean 70_ Dry Dry Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the 18 amount and condition of food remains, with the details contained in the programme overview. You will find the appropriate programme information in the introduction. en Washing dishes Reduce costs!If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Switching the dishwasher ON Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 9 is pressed. The programme starts automatically. Programme data The programme specifications can be found in the summary of instructions. Greater deviations may occur due to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4. Remaining running time display When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly. As the effect is not detected until a programme is running, the time may be longer or shorter than expected. Time delay * * on applicable models You can delay the start of the programme in 1-hour steps up to 19 hours. Press the timer programming button 4 until the digital display 3 jumps to . Keep pressing the timer programming button until the required time is displayed. To delete the timer programming, keep pressing the button until is displayed. You can change your programme selection at any time until the programme starts. Aqua sensor * * on applicable models The Aqua sensor is an optical measuring device which measures the turbidity of the rinsing water. When the Aqua sensor is active, "clean" rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. 4 litres for utensils which are "less" dirty. End of programme The programme has ended when a figure appears in the numerical display 3 . 19 en Switching the dishwasher OFF Several minutes after the programme has ended: Set the main switch 1 to OFF. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. [. . . ] Only this circuit breaker guarantees compliance with the currently valid regulations. Protection from freezing temperatures If the appliance is installed in a location where there is a risk of freezing temperatures (e. g. in a holiday home), all water must be completely drained out of the interior (see "Transporting the dishwasher"). Turn OFF the tap, disconnect the supply hose and allow to drain. Removing the appliance It is essential, when removing the appliance, to observe the following sequence: First, disconnect the appliance from the power supply. Disconnect the waste water and fresh water connections. 28 en Waste disposal Disposal Old appliances are not worthless rubbish. [. . . ]