User manual MAKITA HR2300
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MAKITA HR2300. We hope that this MAKITA HR2300 user guide will be useful to you.
Manual abstract: user guide MAKITA HR2300
Detailed instructions for use are in the User's Guide.
[. . . ] 3)
CAUTION: ⢠Always check the direction of rotation before operation. ¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. [. . . ] Bit angle (when chipping, scaling or demolishing)
For Models HR2310T, HR2610, HR2610T, HR2611F, HR2611FT The bit can be secured at the desired angle. To change the bit angle, rotate the action mode changing knob to the O symbol. 15) Then make sure that the bit is securely held in place by turning it slightly. 16) Press the lock button on the grip base in the direction of arrow shown in the figure and with the lock button being pressed insert the depth gauge into the hex. Adjust the depth gauge to the desired depth by moving it back and forth while pressing the lock button. After the adjustment, release the lock button to lock the depth gauge. Torque limiter
The torque limiter will actuate when a certain torque level is reached. CAUTION: ⢠As soon as the torque limiter actuates, switch off the tool immediately. ¢ Bits such as hole saw, which tend to pinch or catch easily in the hole, are not appropriate for this tool. This is because they will cause the torque limiter to actuate too frequently. Bit diameter Dust cup 5 Dust cup 9
006406
ASSEMBLY
CAUTION: ⢠Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Install the side grip so that the protrusions on the grip fit in between the grooves on the tool barrel. Bit grease
Coat the bit shank head beforehand with a small amount of bit grease (about 0. 24, 25 & 26)
Installing or removing the bit
Clean the bit shank and apply bit grease before installing the bit. 12) After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. 13)
9
NOTE: ⢠If you connect a vacuum cleaner to your hammer, cleaner operations can be performed. Position the bit at the desired location for the hole, then pull the switch trigger. [. . . ] Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Drilling in wood or metal
For Models HR2300, HR2600, HR2601, HR2610, HR2611F Use the optional drill chuck assembly. When installing it, refer to âInstalling or removing the bitâ described on the previous page. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA HR2300
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA HR2300 will begin.