User manual METABO 90 SCS

[. . . ] Pull the plug out of the socket before making any adjustments, converting or servicing the machine. LED (10): Do not view LEDs directly through optical instruments, LED class 1M, classified as per DIN EN 60825-1: 2003, wavelength: 400-700 nm; 300 µs. Specified Use The machine is suitable for sawing non-ferrous metals and sheet steel, wood and similar materials, plastics and similar materials. Generally accepted accident prevention regulations and the enclosed safety information must be observed. [. . . ] - Slacken the screw (19) until the footplate (9) can be raised slightly. - Raise the footplate (9) slightly and slide backwards up to the stop. Commissioning Before plugging in, check to see that the rated mains voltage and mains frequency, as stated on the rating label, match your power supply. Fitting the anti-splintering footplate insert Danger of injury due to the sharp jigsaw blade. Remove the saw blade before fitting (8) the antisplintering footplate insert. Insert the anti-splintering footplate from the front, ensuring the following: • The smooth side of the footplate faces upwards. €¢ The slot is facing to the rear (towards the mains cable). If you wish to work with the protective plate attached (see chapter Accessories 10. Sawing with a guiding device for straight cuts (SCS) The metal guide (5) of the guide element (6) dips into the kerf and stabilises the machine to ensure even straighter cuts. Removing the guide element: - Hold the machine with the footplate down. (Should the guide element not fall out by itself, you can insert the hexagon spanner (16) into the guide element hole and remove it in this way). Inserting the guide element: For straight cuts, insert the guide element so that the metal guide (5) protrudes under the footplate. For diagonal and curved cuts, insert the guide element so that the metal guide (5) fits into the footplate and is not visible. - With the unlocking key pressed, insert the guide element into the footplate. Note: It can only be inserted if the hole in the guide element is facing backwards (towards the mains cable). 3 Inserting the saw blade Danger of injury due to the sharp jigsaw blade. 2 Adjusting the pendulum motion Set the required pendulum motion using the adjustment lever (13). The best way to determine the ideal setting is through a practical trial. 3 Setting maximum speed Set the machine to maximum speed using the setting wheel (17). The best way to determine the ideal setting is through a practical trial. 4 On/Off switch, continuous activation Avoid inadvertent starts: always switch the tool off when the plug is removed from the mains socket or if there has been a power cut. In continuous operation, the machine continues running if it is forced out of your hands. [. . . ] Environmental Protection Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Only for EU countries: Never dispose of power tools in your household waste!In accordance with European Guideline 2002/96/EC on used electronic and electric equipment and its implementation in national legal systems, used power tools must be collected separately and handed in for environmentally compatible recycling. M = Torque T1 = Maximum material thickness in wood T2 = Maximum material thickness in nonferrous metals T3 = Maximum material thickness in sheet steel n0 = Stroke rate at idle speed = Nominal power input P1 P2 = Power output m = Weight without mains cable Measured values determined in conformity with EN 60745. [. . . ]