User manual METABO WX 22-230

[. . . ] Conformity Declaration We, being solely responsible, hereby declare that these angle grinders conform to the standards and directives specified on page 3. D) The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories running faster than their rated speed can break and fly apart. E) The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. [. . . ] If it becomes necessary to remove dust, first disconnect the power tool from the mains supply (use non-metallic objects) and avoid damaging internal components. Pull the plug out of the socket before making any adjustments, converting or servicing the machine. Do not switch on the machine if tool parts or guard devices are missing or defective. Machines with a soft start (indicated by an "X" in the model designation): An electronic error occurs if the machine accelerates to maximum speed very quickly when switched on. Use elastic cushioning layers if they have been supplied with the abrasive and if required. Rotatable main handle (depending on features) Only work with the main handle (9) engaged. - The main handle (9) can now be turned 90° to both sides and can be engaged. - Make sure that it is securely positioned: the main handle (9) must be engaged and it should not be possible to move it. 4 Power supply The mains sockets must be protected using timedelay fuses or circuit breakers. Machines with "X" in the model designation: (with integrated, automatic restriction of the starting current (soft start)). The mains sockets can also be protected using fast-acting fuses or circuit breakers. Commissioning If delivered without a mains plug, arrange for a suitable mains plug to be connected by a qualified electrician ONLY. Before plugging in, check to see that the rated mains voltage and mains frequency, as specified on the rating label, match your power supply. The extension cable must be suitable for the machine power rating (see Technical Specifications). 1 Attaching the additional handle Always work with the additional handle attached (10)!Manually screw in the additional handle securely in the left, centre or right threaded hole (depending on requirements). 2 Attaching the safety guard (for work involving grinding wheels) Prior to commissioning: Fit the protective cover. Attaching the grinding wheel Disconnect the mains plug before changing any accessories. For reasons of safety, attach the parting guard before performing parting work (see chapter 11. Locking the spindle Press in the spindle locking button (4) only when the spindle is stationary!- Press in the spindle locking button (4) and turn the spindle (3) by hand until you feel the spindle locking button engage. - Position the grinding wheel on the support flange (2) as shown in illustration C. [. . . ] Only for EU countries: Never dispose of power tools in your household waste!In accordance with European Guideline 2002/ 96/EC on used electronic and electric equipment and its implementation in national legal systems, used power tools must be collected separately and handed in for environmentally compatible recycling. Permitted thickness of accessory M = Spindle thread l = Length of the grinding spindle n = No-load speed (maximum speed) P1 = Nominal power input P2 = Power output m = Weight without mains cable Measured values determined in conformity with EN 60745. Machine in protection class II ~ Alternating current The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards). [. . . ]