User manual MINOURA BIKE TOWER

[. . . ] BIKE TOWER Instructions Manual Thank you for purchasing Minoura BIKE TOWER display stand. Thsi is the display stand which can hold 2 or more bikes (limit 4 bikes) on its cradles at two different heights and in front and behind the pole. [. . . ] A) +20mm ! A loose the bolt on the pole joint may cause the pole to slide down when a bicycle is in the cradle. Overtightening the bolt on the pole joint may cause the plastic pole joint to break. Make sure the pole joint bolt is snug and that the joint will not move. loosen and tighten (Fig. Place the Angle Adjust Plate onto the Lower Support, then put the Alloy Stay on it. C) Screw the supplied M6x15 bolt in the lower hole, but you don't need to tighten it so firmly at this time. C) 4 The distance between the plastic frame hooks can be adjusted to fit different sized bicycles. D) Now, disassemble the supplied stainless band device by removing the bolt. Wind the stainless band around the pole, and insert the end of the band into the gap between another end and the rectangle nut. Holding it in place, put the plastic bracket and assembled cradle together, then tighten them down with the bolt you removed earlier. E) The stainless band must ONLY be used on the upper side of the cradle. Failure to do so may cause the bicycle to slip down the pole. (Fig. First, put the upper rubber cup against the ceiling and push the pole up to contract and shorten the inside spring. [. . . ] MINOURA JAPAN 1197-1 Godo, Anpachi, Gifu 503-2305 Japan Phone +81-(0)584-27-3131 / Fax +81-(0)584-27-7505 Email : minoura@minoura. jp http://www. minoura. jp MINOURA NORTH AMERICA (for North American residents only) 1996 East Avenue, Hayward, CA 94541-5454 U. S. A. Fax 1-510-538-5899 / Email : MinouraUSA@ATTglobal. net Made & Quality Controlled in Japan Copyright 2002 Minoura Co. , Ltd. [. . . ]