User manual MORLEY PEDALS SPRINGWOUND

[. . . ] And Step On It. SPRING REPLACEMENT INSTRUCTIONS FOR: MARK 1, VAI-1, VAI-2, PBA, PBA-2, NSW OR WAH-SP (wound spring style) Follow the below instructions to replace a broken or fatigued spring on any of the above mentioned pedal models. Tools you will need: - 12 mm nut driver - 5/16" nut driver - 1/4" nut driver - Phillips Screwdriver (medium tip) - Long tip Needle-nose pliers (2" long tip) - 3/8" Wrench (Open end or Box end) DISASSEMBLY 1) Remove four bottom cover screws using Phillips screwdriver. [. . . ] Although the diagrams show a pedal with a base, the spring is to be assembled to the treadle/treadle bracket first. 2) Diagram #2 shows the proper assembly order of spring and associated components. 3) Place all components (per diagram #2) into place. 4) Place base onto treadle and align screw hole openings in base to line up with holes in treadle bracket. Using the needle-nose pliers, hold the 6-32 x 1/2" Phillips pan head screw by the head and insert from underside of treadle bracket. (The thread should stick up in the inside of the pedal base) Replace washer and 5/16" nut. This can be accomplished by setting the pedal assembly on its heel end, pushing the treadle as far toward the toe end as possible and visually centering the treadle so it is not cocked to the right or left. This is important so the shutter is located properly between the optics. [. . . ] 13) Diagram #3 shows the assembled spring. If you need further assistance, please call 1-800-284-5172 Bill Wenzloff ext 12 Chad Montrose ext 14 [. . . ]