User manual NIKON SL-1 MACRO COOL-LIGHT (SUPPORTS COOLPIX 775, 880, 885, 950, 990, 995, 4300, 4500, 5000)

[. . . ] ) -- one thing your camera's built-in Speedlight may not be able to do. * The COOLPIX 775 , 880 , 885 , 950 , 990 , 995 , 4300 , 4500 and 5000 can all accommodate the MACRO COOL-LIGHT SL-1. NOTE: Please refer to "Specifications" for important information regarding the use of the SL-1 with the COOLPIX 5000 digital camera. [. . . ] D) 3 Insert the batteries with the "+" and "­" ends positioned as marked inside the battery chamber. Make sure that the tip of the flexible tab inside the battery chamber sticks out as shown. E) (The flexible tab is used when removing exhausted batteries from the chamber. ) 4 Set the power switch on the SL-1 to ON and confirm that the lights are on. (If you are not going to use the SL-1 right away, please turn the power off. When Using the Optional AC Adapter EH-53, EH-31, EH-30 or EH-21 (Illustration shows the COOLPIX 4500 and the EH-53) The SL-1 must already be attached to the camera before the AC Adapter can be connected to the SL-1. C) 2 Insert the DC plug of the AC Adapter into the DCin connector of the SL-1 /, and insert the wall plug of the AC Adapter into a wall socket ¤. H) 3 Set the power switch on the SL-1 to ON and confirm that the lights are on. (If you are not going to use the SL-1 right away, please turn the power off. ) · When an AC Adapter is connected to the SL-1 while 3V lithium batteries are still in the chamber, power is supplied by the AC Adapter. (The SL-1 can be attached to the COOLPIX 800, 900 and 910 as well, but proper lighting cannot be attained. ) · Since the SL-1 uses spot light source (LED), the image of the light source itself might be exposed depending on the subject · Attaching the SL-1 increases the total weight of the camera, thus increasing the chance of picture blur occurring. When the SL-1 is attached to the camera, do not attempt to hold the camera by the SL-1 alone. When carrying or transporting the camera, please make sure that the SL-1 is detached. ⷠThin wrist straps such as those used with mobile phones can also be attached to the SL-1. Be careful not to pull on the strap when the SL-1 is attached to a camera, as this can result in damage to the SL-1 and the camera. [. . . ] 3 Turn the attachment wheel lock counterclockwise to disengage it 1, adjust the position of the battery chamber so it is best suited for taking pictures 2, then turn the attachment wheel lock clockwise to fix the SL-1 in place. Two CR2-type 3V lithium batteries; optional external power supply (6-8. *2 Normally you can use the wide-to-middle zoom range in Macro close-up photography up to 2cm (0. [. . . ]