User manual NINTENDO WII BALANCE BOARD

[. . . ] Failure to do so may result in injuries or damage to the system or other property. Observe children during gameplay for proper and safe use of the board. An adult should assist young children when first playing to make sure they understand correct use. To prevent injury and/or to prevent damage to the Wii Balance Board or surrounding objects, follow these guidelines during gameplay: · Be aware of your balance so that you do not slip or fall from the board. [. . . ] ⷠThis procedure must be followed for each Wii Balance Board compatible Game Disc. ⷠThese synchronization settings will be saved even if the console is turned off. ⷠThis procedure can be completed only if a compatible Game Disc is running in the console. Press the EJECT Button on the front of the Wii console and remove any game disc if necessary. NOTE: Close the SD Card slot cover when you are finished with the synchronization procedure. Make sure you have adequate space between you and any other objects or people during gameplay. The balance sensors must contact the floor directly for proper operation. If carpet or other material contacts the bottom of the board, use the included foot extensions. IMPORTANT: The Wii Balance Board will not work until it has been synchronized with your Wii console. NOTE: Replace the Battery Cover when you are finished with the synchronization procedure. The Power LED on the board will start blinking (for up to about 20 seconds). Most of the basic activities involving the Wii Balance Board are done using the positions shown below. There may be other ways of gameplay depending on the type of game you are playing. Review the instruction booklet for the game you are playing for further information. Also refer to the Health and Safety Information on page 2 of this manual and the Health and Safety Information and operating instructions in the Wii Operations Manual - System Setup that came with your Wii system. IMPORTANT: Do not press and hold the SYNCHRO Button on the Wii console down for more than 10 seconds. This will delete all of the Standard Mode synchronization information for all Wii Remotes that you use with that console. The Power LED will stop blinking and light steadily once the synchronization is complete. Please refer to the instruction booklet for the Game Disc you are using for further information on gameplay. nOTE: · Only one Wii Balance Board can be synchronized to a Wii console at a time. Up to a total of 10 Wii Remotes and accessories can be synchronized to a console at any time with the Standard Mode procedure. If additional synchronizations are made, the oldest existing ones will be overwritten. [. . . ] If your Wii Balance Board does not operate correctly after all of the above steps, visit support. You may need only simple instructions to correct a problem with your product. Com or call our Consumer Assistance Hotline at 1-800-255-3700, rather than going to your retailer. If the problem cannot be solved with the troubleshooting information available online or over the telephone, you will be offered express factory service through Nintendo. [. . . ]