User manual PANASONIC KX-DT321

[. . . ] *3 The default setting is Automatic. 4 Document Version 2009-03 Features List Features List Icon Meanings (CO) = Flexible button = Feature number = Off-hook = Talk C. Tone = On-hook = Confirmation Tone Making Calls Calling To an extension extension no. To an outside party (CO) outside phone no. Redial REDIAL Quick Dialing quick dial no. One-touch Dialing To store PROGRAM (CO) desired no. * (max. 32 digits) AUTO DIAL PROGRAM STORE * Enter CO line access number before outside phone number. To dial assigned as a (One-touch One-touch Dialing Dialing) button Document Version 2009-03 5 Features List Personal Speed Dialing To store personal speed dial no. [. . . ] Gently rotate the stand in the direction indicated until it is released. Cabling When using the stand, ensure that the cords are clamped as shown. Clamp Document Version 2009-03 11 Stand Usage Adjusting from High to Low Position Hold the stand with both hands as shown and rotate the stand in the direction indicated until it locks into the low position ( B ). B 1 Adjusting from Low to High Position Hold the stand with both hands as shown and rotate the stand in the direction indicated until it locks into the high position ( A ). 1 A 12 Document Version 2009-03 Wall Mounting Wall Mounting 1. Drive the 2 screws (included) into the wall either 83 mm (3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on the wall. · You can find a wall mounting template on page 19. · Make sure that the wall that the unit will be attached to is strong 83 mm enough to support the unit (3-1/4 in) (approx. 100 mm · Make sure that the telephone (3-15/16 in) line cords are not trapped or pinched against the wall. · Make sure the cords are Washer securely fastened to the wall. Drive the screw · When this unit is no longer in to this point. use, make sure to detach it from the wall. Locking the Handset Hook Pull down the handset hook until it locks to prevent the handset from falling off the handset cradle when the unit is mounted to a wall or set at a high angle. To temporarily place the handset down during a conversation, hook it over the top edge of the unit as shown. Document Version 2009-03 13 Important Information Important Information When using a KX-DT321 DPT, keep the following conditions in mind. · If you are having problems making calls, unplug the extension line and connect a known working telephone. If the known working telephone operates properly, have the defective telephone repaired by an authorized Panasonic factory service center. If the known working telephone does not operate properly, check the PBX and the internal extension wiring. Do not clean the unit with abrasive powders or with chemical agents such as benzene or thinner. The unit must only be disassembled and repaired by qualified service technicians. · If damage to the unit exposes any internal parts, immediately disconnect the cable or cord. into the vents or other holes of this unit. Take special care to follow the safety suggestions listed below. Installation Environment 1) Do not use this unit near water, for example, near a bathtub, washbowl or sink. 2) Keep the unit away from heating appliances and devices that generate electrical noise, such as fluorescent lamps, motors, and televisions. [. . . ] When programming emergency numbers and/or making test calls to emergency numbers: 1) Remain on the line and briefly explain to the dispatcher the reason for the call before hanging up. 2) Perform such activities in the off peak hours, such as early morning hours or late evenings. Document Version 2009-03 17 Important Information Customer Information This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of the cabinet of this equipment is a label that contains, among other information, the following product identifier: US: ACJKXNANKX-DT321 If requested, this number must be provided to the telephone company. [. . . ]