User manual PANASONIC KX-TG6421FX

[. . . ] TG6411-6421FX(e). book Page 1 Friday, February 27, 2009 11:44 AM Operating Instructions Digital Cordless Phone Model No. KX-TG6411FX KX-TG6412FX KX-TG6421FX Digital Cordless Answering System Model No. Model shown is KX-TG6411. Thank you for purchasing a Panasonic product. You must subscribe to the appropriate service offered by your service provider/telephone company. To use this unit in your country, first change the unit's region setting to match your country (page 25). (For Czech and Slovakia) This cordless telephone is possible to use according to General licence No. : VO-R/8/08. 2005-23 (for Czech), VPR-7/2001 (for Slovakia). [. . . ] Editing a number: 8 i {V}/{^}: "Edit" i M i Press {^} or {V} to move the cursor. i M i {ih} Erasing a number: 8 i {V}/{^}: "Erase" i M i {V}/{^}: "Yes" i M i {ih} 1 2 3 4 Handset: 8 (middle soft key) {V}/{^}: "Handset Setup" i M {V}/{^}: "Register H. set" i M Base unit: Proceed with the operation for your model. (No registration tone) KX-TG6421 Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L The next step must be completed within 90 seconds. Note: L When editing, press the desired dial key to add, ^ to erase. Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to the base unit. Important: L The additional handset model recommended for use with this unit is noted on page 5. If another handset model is used, certain operations 5 Handset: Wait until "Base PIN" is displayed. i M L If you forget your PIN, contact your nearest Panasonic service centre. L When the handset has been registered successfully, w stops flashing. 27 TG6411-6421FX(e). book Page 28 Friday, February 27, 2009 11:44 AM Programming Note: L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. Important: L Before registering the repeater to this base unit, you must turn the repeater mode on. Setting the repeater mode 1 2 3 4 8 (middle soft key) {V}/{^}: "Base Unit Setup" i M {3}{3}{5} {V}/{^}: "Cancel Register" i M L The numbers of all handsets registered to the base unit are displayed. Select the handset(s) you want to cancel by pressing the desired handset number. {V}/{^}: "Yes" i M L A confirmation tone sounds as each handset number disappears. {ih} 1 2 3 4 8 (middle soft key) {V}/{^}: "Base Unit Setup" i M {V}/{^}: "Repeater" i M {V}/{^}: Select the desired setting. i M i {ih} 5 Note: L After turning the repeater mode on or off, w flashes on the handset momentarily. This is normal and the handset can be used once w stops flashing. 6 7 Increasing the range of the base unit You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT 28 TG6411-6421FX(e). book Page 29 Friday, February 27, 2009 11:44 AM Caller ID Service Using Caller ID service Important: L This unit is Caller ID compatible. Contact your service provider/ telephone company for details. phonebook is displayed and logged in the caller list. Caller list Important: L Only 1 person can access the caller list at a time. L Make sure the unit's date and time setting is correct (page 16). Caller ID features When an outside call is being received, the caller's phone number is displayed. Caller information for the last 50 callers is logged in the caller list from the most recent call to the oldest. [. . . ] L If your unit is connected to any additional telephone equipment, remove and plug the unit directly into the wall jack. L If you use a DSL/ADSL service, we recommend connecting a DSL/ADSL filter between the base unit and the telephone line jack. L Depending on your service provider/ telephone company, the unit may display the caller's information at the 2nd ring or later. L Incorrect time information from incoming Caller ID changes the time. [. . . ]