User manual PANASONIC KXTG7521E

[. . . ] TG7521E(e). book Page 1 Friday, January 22, 2010 8:46 AM Operating Instructions Digital Cordless Answering System Model No. KX-TG7521E KX-TG7522E KX-TG7523E KX-TG7524E Model shown is KX-TG7521. Before initial use, see "Getting Started" on page 9. Thank you for purchasing a Panasonic product. Please read these operating instructions before using the unit and save them for future reference. You must subscribe to the appropriate service offered by your service provider/telephone company. Please access our online customer survey: http://panasonic. net/pcc/tel/q TG7521E(e). book Page 2 Friday, January 22, 2010 8:46 AM Table of Contents Introduction Model composition . [. . . ] 01289 8333 29 TG7521E(e). book Page 30 Friday, January 22, 2010 8:46 AM Programming From the caller list: 3 1 2 3 4 1 2 3 {<} (y) {V}/{^}: Select the entry to be barred. i M i I {V}/{^}: "Caller Barred" i M {V}/{^}: "Yes" i M i {ic} 1 i {#}{2}{1}{7} i m Enter the phone number (24 digits max. ). i M i {ic} Registering a unit Operating additional units Additional handsets Up to 6 handsets can be registered to a single base unit. Important: L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc. ) may not be available. Additional base units Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when "Auto" is selected on base unit (page 31), it looks for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a "radio cell". Note: L Calls are disconnected when the handset moves from one radio cell to another. By entering phone numbers: Viewing/editing/erasing bar call numbers 1 2 3 1 i {#}{2}{1}{7} {V}/{^}: Select the desired entry. i M i {ic} To erase a number: W i {V}/{^}: "Yes" i M i {ic} Note: L When editing, press the desired dial key to add, ^ to erase. Changing the base unit PIN (Personal Identification Number) Important: L If you change the PIN, please make note of your new PIN. If you forget your PIN, see page 53. Registering a handset to a base unit The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, _ is displayed even when 1 2 30 1 i {#}{1}{3}{2} Enter the current 4-digit base unit PIN (default: "0000"). Helpline Tel. 01289 8333 TG7521E(e). book Page 31 Friday, January 22, 2010 8:46 AM Programming the handset is near the base unit), reregister the handset. 2 1 2 Handset: 1 i {#}{1}{3}{0} {V}/{^}: Select a base unit number. Base unit: Press and hold {x} for about 5 seconds, until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop. L When the handset has been registered successfully, w is displayed. {V}/{^}: Select the desired base unit number, or "Auto". i M L The handset starts searching for the base unit. 3 Deregistering a handset A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system. 1 2 3 1 i {#}{1}{3}{1} L All handsets registered to the base unit are displayed. {ic} 4 4 Note: L While registering, "Base in registering" is displayed on all registered handsets. L When you purchase an additional handset, refer to the additional handset's installation manual for registration. Selecting a base unit When "Auto" is selected, the handset automatically uses any available base unit it is registered to. When a specific base unit is selected, the handset makes and receives calls using that base unit only. [. . . ] L If you subscribe to a voice mail service, messages are recorded by your service provider/telephone company, not your telephone. Change the unit's number of rings setting or contact your service provider/telephone company (page 44). L Record your own greeting message again (page 41). My own greeting message cannot be properly heard. I cannot operate the answering system. L Someone is using the unit. [. . . ]