User manual PANASONIC MJL500

[. . . ] €¢ Please read these instructions carefully to use the product correctly and safely. €¢ Before using this product please give your special attention to “Safety Precautions” (Page GB3-8). €¢ Please keep this Operating Instructions for future use. K only) Parts Names and Handling Instructions Before Use • Disassembly and assembly of the parts • Safety Lock • Preparations of ingredients for juicing • Preparations of ingredients for frozen dish How to Use How to Clean Troubleshooting Circuit breaker protection Replacement Parts Specifications Recipes Page GB3 GB9 GB10 GB11 GB12 GB14 GB15 GB16 GB17 GB18 GB20 GB21 GB21 GB21 GB22 Safety Precautions WARNING: CAUTION: Please make sure to follow these instructions. [. . . ] How to replace the fuse The location of the fuse differs according to the type of AC mains plug (figures A and B). Open the fuse cover with a screwdriver and replace the fuse and close or attach the fuse cover. Figure A Figure B Fuse cover cover Parts Names and Handling Instructions W  ● ash all the detachable parts before using the appliance for the first time or when you have not used it for a while. GB18) Accessories Food pusher Juice container Pulp container Feeding tube Lid Cleaning brush Squeezing Screw The tip of the handle can be used to remove pulp from juice spout or pulp spout. ) • This button can be used when the ingredients are jammed. GB10 GB11 Before Use -Disassembly and assembly of the partsDisassembling/Assembling attachments ● The following steps show how to disassemble/assemble attachments, using the juice attachment as an example. The frost attachment can be disassembled/assembled in the same method. To disassemble To assemble 1 2 Remove the bowl from the motor housing. 1 Make sure the gasket, rubber plug and rubber brushes are in place correctly. Align the “” mark on the motor housing and the “” on the juicing bowl. Squeezing Screw 3 Attach the rotating brush and filter, then set it on the motor housing. Align the “” mark on the motor housing and the “” mark on the juice attachment. Outer bottom view ● Rubber brushes are located on side of the rotating brush. R 2 otate the squeezing screw and push it into the hole until it stops. The lid cannot be closed if the squeezing ● screw is not pushed down sufficiently. Be ● careful not to get your finger clamped in the gap between the squeezing screw and the filter. Filter ① ● ② ● Rotating brush ( Frost ) attachment See page GB19 for how to install the gasket, rubber plug and rubber brushes. — The juicer may not work properly if they are not assembled correctly. GB12 GB13 Before Use -Disassembly and assembly of the parts- (Continued) Disassembling/Assembling the lid To assemble Before Use -Preparation of ingredients for juicingProhibited ingredients Ingredients that may cause part damages ● Ice and frozen ingredients ● Seed of peach, plum, mango etc. Rotor GB14 GB15 Before Use -Preparations of ingredients for frozen dishProhibited ingredients <Ingredients that may cause part damages> ● Ice and deeply frozen ingredients. With frost attachment How to use Extracting Preparations 1 Install parts on the motor housing and assemble the lid. —  hen using the frost attachment, placing the pulp W container is not necessary. [. . . ] ) Dishwasher safe parts ● Before putting the parts into a dishwasher, remove residue on the parts. Always place the parts away from any heater or set a low temperature of heater. Storage ● To avoid formation of rust, dry the parts after washing. — To avoid failure, do not place the motor housing up-side down. [. . . ]