User manual PANASONIC TY-WK6P1RW

[. . . ] Otherwise the unit may be dropped and become damaged, and personal injury may result. Do not fit at any locations subject to humidity, dust, smoke, steam or heat. The work of fitting or removing the plasma TV must be performed by at least two people. This may cause heat to build up inside the plasma TV unit, resulting in a fire. [. . . ] Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction. Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work. When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened. Take sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work. Lay the base upper and lower fittings and the bracket base left and right fittings and as shown in the figure. Fit the protrusions (tabs) of the bracket base left and right fittings into the cutouts (2 on the left and 2 on the right) in the base upper and lower fittings, and secure the parts using the eight screws for assembling the fixture. Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Base lower fitting (side with the label attached) M5 × 10 screws for assembling the fixture Refer to the instruction manual of the plasma TV, and check the weight of the plasma TV unit which will be fitted into the wall-hanging bracket. refer to the outline drawing of the wall-hanging bracket shown on the right , and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement. notes · There are nine pre-drilled mounting holes at the top and another nine at the bottom of the wall-hanging bracket. Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right. However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together. Mount or place only a plasma TV on the fixture: Do not mount or place any other product. Use a level to ensure that the fixture is not tilting on one side, and then secure the screws in the five remaining holes. notes · If it is necessary to embed screws or nuts in the wall prior to installing the wallhanging bracket because the wall is made of concrete or such other materials, determine the positions of the holes by fitting the actual wall-hanging bracket or calculating from the figures shown in the outline drawing, and then embed screws or nuts with a nominal diameter of 6 mm (0. If you are embedding the screws, make sure they protrude from the wall surface by 10 to 15 mm (0. For installing the wall-hanging bracket onto the wall, use screws with a nominal diameter of 6 mm (0. 2 inches) or their equivalent available from a hardware store and suited to the materials of the installation area on the wall. The angle of this wall-hanging bracket can be adjusted in 5-degree increments to one of three positions ranging from "0-degree (Zero tilting)" to "10-degree tilting". When the wall-hanging bracket is shipped from the manufacturing plant, the angle is set to "0-degree (Zero tilting)". [. . . ] While lifting the bottom part of the plasma TV, pull the plasma TV toward you. Once the insulation spacers at the bottom have been released, lift the plasma TV straight up. note · Only a professional should remove the plasma TV from the wallhanging bracket. Detta kan leda till överhettning inuti plasma-TV:n och skapa risk för brand. [. . . ]