User manual PHILIPS AEA3000

[. . . ] Servicing is required when the apparatus has been damaged in any way, such as liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. k Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: • Install all batteries correctly, + and - as marked on the unit. • Remove batteries when the unit is not used for a long time. l Apparatus shall not be exposed to dripping or splashing, keep it away from direct sunlight, naked flames or heat. [. . . ] If you contact Philips, you will be asked for the model and serial number of this apparatus. ___________________________ b d c a a Line out socket • (To use the microphone separately) connect to the MIC input socket of an existing Hi-Fi system. b Battery compartment c OFF/ON • Switch the microphone on or off. d Power indicator • Light up red when the wireless microphone is switched on. Receiver Introduction With the Philips wireless microphone and receiver, you can: • connect the receiver to your iPad (or both your iPad and an existing Hi-Fi system), and sing along with music from the app (The Voice: On Stage) through the wireless microphone. What's in the box Check and identify the contents of your package: • Wireless microphone • Receiver • 3 x AAA batteries • Quick start guide • Safety sheet a iPad connector a b c b Bluetooth® indicator • Indicate the Bluetooth® status. c LINE-OUT • Connect the receiver to an existing Hi-Fi system. Overview of the unit Wireless microphone 4 EN Always follow the instructions in this chapter in sequence. Install/replace microphone batteries Caution •• Risk of explosion!Keep batteries away from heat, •• Danger of explosion if batteries are incorrectly sunshine, or fire. •• Batteries contain chemical substances, so they should be disposed of properly. 3 Push back the battery cartridge, then close the battery compartment. Note •• If you are not going to use the microphone for a long •• New batteries installed in the microphone support up time, remove the batteries. to 30 hours of continuous use. 1 Open the battery compartment and take out the battery cartridge. •• When the power indicator flashes red, it indicates that the power level is low and you need to replace the batteries. 2 Insert 3 x AAA batteries (supplied) into the cartridge with correct polarity (+/-) as indicated. EN 5 English 3 Get started 4 Play Sing along through the wireless microphone Note •• The effective operation range between the wireless microphone and receiver is approximately 10 meters (30 feet). 4 Slide the OFF/ON switch on the wireless microphone to the ON position. »» The Bluetooth® indicator on the receiver flashes blue. »» The wireless microphone starts to pair with the receiver automatically. »» After successful pairing and connection, the Bluetooth® indicator turns solid blue. 1 Connect your iPad to the receiver. »» A prompt pops up on the iPad screen, asking you to install the relevant app. 5 Find and download a tutorial from The Voice: On Stage, then tap Sing->RECORD for how to sing along through the wireless microphone and iPad. 2 3 Tap YES on the prompt to install the app (The Voice: On Stage) from Apple App Store. After successful installation, run The Voice: On Stage on the iPad. 6 Select a song from The Voice: On Stage and sing along through the wireless microphone. 6 EN 2 Power on the existing Hi-Fi system and select the 3. 5mm audio input source (see the user manual of the Hi-Fi system for detailed operation). Tip •• If the wireless microphone remains disconnected from the receiver for more than 15 minutes, it switches to standby mode automatically. [. . . ] To switch it on again, you need to slide the OFF/ON switch on the microphone to the OFF position and then back to the ON position. •• Adjust volume on the Hi-Fi system connected to the receiver. •• Make sure that you have selected the correct source on the connected Hi-Fi system. [. . . ]