User manual PHILIPS HD5702

[. . . ] In this user manual you find all the information you need to optimally enjoy your espresso maker. Important Read this user manual carefully before you use the appliance and save it for future reference. If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Note:You can interrupt the brewing process at any time by pressing the cappuccino button or latte machiatto button again. If the appliance runs out of milk during brewing: 1 Remove the milk jug and refill it. 3 Press the cappuccino button or latte macchiato button again for a new cup. , The appliance grinds the beans , adds the frothed milk and brews the coffee. 8 If there is still milk in the milk jug, put the milk jug with the lid on it in the fridge after use. Cleaning the milk jug Clean the milk frothing pipe after brewing cappuccino or latte macchiato, after frothing milk and when the milk jug is empty. For more thorough cleaning, you can remove the milk jug from the appliance and clean the jug, the lid, the milk frothing pipe and the milk intake tube manually. Cleaning the milk frothing pipe with the CLean button 1 Place a bowl under the milk frothing pipe. , Hot water comes out of the milk frothing pipe as long as you press the CLEAN button. Cleaning the complete milk jug 1 Remove the lid from the milk jug and detach the milk frothing pipe and the milk intake tube. Clean all parts thoroughly with hot water and some washing-up liquid or in a dishwasher. , After about 5 minutes, the message `DESCALE DONE - Push OK when ready' appears on the display. You now have to flush the appliance to remove descaler residues from the inside of the appliance. 10 Empty the full bowl and then put it back under the hot water spout. The descaling program is now finished and the appliance is ready to brew coffee again. Note: If the descaling program is interrupted before completion, the appliance continues to display the message `PLEASE DESCALE!Press the ^ or % button until the desired coffee temperature is displayed (low, medium or high). This function allows you to set a time at which the appliance automatically switches on. 1 Make sure the clock on the appliance is set as described (see section `Setting current time' in this chapter). Note:When you switch off the appliance while an auto-on time is set, the > symbol appears next to the time on the unlit display. Setting auto-off time The appliance is factory preset to switch off automatically one hour after the last cup of coffee is brewed. Press the ^ or % button to change the number of hours after which the appliance switches off automatically. [. . . ] Use a needle to scrape dried coffee residues out of the blocked spout hole. When I press the button for short, standard or long coffee, water instead of coffee comes out of the appliance. I want to brew espresso from ground coffee, but no espresso comes out of the appliance. The funnel for ground coffee Switch off the appliance and unblock the funnel is blocked. [. . . ]