User manual PHILIPS MC170

[. . . ] Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). This set complies with the radio interference requirements of the European Community To avoid overheating of the set a safety circuit has been built in. If this happens, switch the set off and let it cool down before reusing it. Look into the instruction manual of the appliance on how to connect and operate it. [. . . ] 4 Operate your appliance as usual and adjust volume and sound with the set. Note: The effect of INCREDIBLE SURROUND may vary with different types of music. 2 Press MUTE on the remote control again to reactivate the sound reproduction. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company. 1 Press SLEEP on the remote control until the desired sleeper time is displayed. © SLEEP, 60, 45, 30, 15, 10, OFF 2 As soon as the desired time is displayed, do not press the key again. It is possible to set the clock by using a time signal which is broadcast with RDS stations. The set can be used as an alarm clock, whereby the CD or tuner is switched on at a set time. Note: The time signal broadcasted from certain RDS stations may not always be accurate. To clean the CD, wipe it in a straight line from the centre toward the edge using a soft, lintfree cloth. 2 To review your program keep PROGRAM depressed for more than 2 seconds. Note: If you try to store more than 20 tracks the display shows PROGRAM FULL. You can select up to 20 tracks and store them in the memory in a desired sequence. © PROGRAM CLEARED is displayed once, PROGRAM goes off and the program is erased. Note: The program will also be erased if you ­ interrupt the power supply, ­ open the CD tray. The set can select and programme stations by itself or you can choose them yourself. © PROGRAM goes off, the preset number and the frequency of the preset station are displayed. If the signal of a FM transmitter is too strong or too weak it is possible to adjust the antenna sensitivity. If you are receiving a RDS station, R and the station name are displayed. [. . . ] switching through different RDS information · Press RDS on the set repeatedly to switch through the following information (if available): ­ Frequency ­ Program type such as: NEWS, SPORT, POP M, . To tune to a weak station briefly press 11 TUNING 22 (5 or 6 on the remote control) as often as necessary for optimum reception. It is possible to set up the tuner in a way that listening to a CD is interrupted by the news of a RDS station. Press 4 PRESET 3 until the preset number of the desired station is displayed. [. . . ]