User manual PLEXTOR ULTRA-A

[. . . ] FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee interference will not occur in a particular installation. [. . . ] They allow the internal SCSI connector on your soundboard to be linked or connected to your external drive. If they were not provided by your soundboard manufacturer, you will need to purchase them from a local computer supply store. See the discussion about device drivers in Chapter 9 of this manual. Once you have assembled everything you need, you're ready to install your drive. But first, a few words of caution are in order. 8 ULTRAPLEX OPERATION MANUAL ---- CHAPTER 4 ---- Precautions YOUR TASK: YOUR OBJECTIVE: YOUR METHOD: Read the list of precautions below. Review the list and use common sense. Your new CD-ROM drive is a precision electromechanical device. Like the rest of your computer system, it requires reasonable care in its installation and use. Please read this manual carefully and keep it handy for easy reference. See your dealer, or call Plextor's Technical Support Department, should your drive require repair or service. # Do not put your computer monitor (or any other device weighing more than 30 lbs. ) on top of the UltraPleX external drive. # Do not place your drive in direct sunlight, on heating units, or near electrical appliances that draw large amounts of current, such as a high-powered audio amplifier, microwave oven, toaster, hair dryer, etc. Keep the area around your drive clean from dust, smoke, and other contaminants. Do not allow moisture or liquids such as water, cleaning fluids, or solvents to touch the drive. Thinner, benzene, or alcohol-based solvents can mar your drive's surface. To help ensure that your CD-ROM discs remain free of dirt or other contaminants, they should be stored in a jewel case. Do not insert a warped, poorly balanced, or cracked disc or caddy into the drive. Removing the cover may expose you to harmful electrical voltages or the laser beam. For your safety, entrust service to Plextor-authorized service personnel only. ULTRAPLEX OPERATION MANUAL 9 ---- CHAPTER 5 ---- Drive Features YOUR TASK: YOUR OBJECTIVE: Get to know your drive. Match the parts of your drive to the diagrams below. YOUR METHOD: PX-32CS (Caddy) Drive----FRONT PANEL(Int. /Ext. ) Door Closed Front Door Caddy Slot Emergency Eject Hole Stop/Eject Button Headphone Jack Volume Control Audio CD Play Button DISC Indicator ON/BUSY Indicator Front Door: Press eject button to open and insert disc. Emergency Eject Hole: Insert paper clip, or other thin, rigid object to eject caddy if automatic eject button does not work. During Audio CD play mode, however, push once to stop audio play and twice to eject. Off when disc is inserted and not being accessed. 10 ULTRAPLEX OPERATION MANUAL CHAPTER 5 ---- Drive Features DISC Indicator: Green when power is on and disc is inserted. Headphone Jack: Stereo mini-jack for headphones and powered speakers. PX-32TS (Tray) Drive----FRONT PANEL (Int. /Ext. ) Door Closed Front Door Tray Drawer Emergency Eject Hole Stop/Eject Button Headphone Jack Volume Control Audio CD Play Button DISC Indicator ON/BUSY Indicator Front Door: Press eject button to open and insert disc. Emergency Eject Hole: Insert paper clip, or other thin, rigid object to eject caddy if automatic eject button does not work. During Audio CD play mode, however, push once to stop audio play and twice to eject. [. . . ] However, if you are in an environment where you want to prevent others from borrowing or stealing the disc inserted in your drive (e. g. , the drive is located in a public place where multiple users have unlimited access), you can activate the Eject Lock feature. When this switch/jumper is ON, it is impossible to eject a disc inserted in the drive by pressing the Eject button. A software eject command must be issued for the disc to eject from the drive. Check your device driver manual for instructions on how to issue a software eject command. [. . . ]