User manual PVG 3900

[. . . ] Your heater has been designed for use with high-quality water-free pure paraffin oil. Lower quality fuel may result in: Only the use of the correct fuel will ensure safe, efficient, and comfortable use of your heater. Increased possibility of malfunctioning incomplete burning reduced heater lifetime smoke and/or smells deposits on the grid or mantle Using the right fuel is therefore essential for safe, efficient, and comfortable use of your heater. Only this cap ensures trouble-free transportation of the heater after use. [. . . ] ) to set switch on the function (the TEMP light next to the information display ¹ will start blinking). Next, adjust the temperature using the key on the right ( the temperature to a higher setting and the key on the left ( hour) to lower the Seconds the light will stop blinking and the setting will be locked (Fig. When the heater has been unplugged (or after a power failure), the temperature will reset to the factory setting of 20°C. In order to switch on the timer, the correct time must have been set (refer to Section C) and the heater should be off. Follow the procedure below: 1 Press the button and then the TIMER key immediately after that. 2 Use the adjustment keys Use the key on the left ( To set the time at which the heater must ignite. Hour) to set the hours and the key on the right Again and the TIMER indicator light will light up, indicating that the timer function has been activated (Fig. When you want to switch off the heater and ignite it again with the timer, all you have to do is press the TIMER key (refer to Section G). 2 Press the TIMER key , when you want to switch off the heater and ignite it Again with the timer the next time. This not only switches off the heater, but it also activates the timer function. You can change the required time with the adjustment keys (refer to Section F). The information display ¹ not only serves as an indicator of the (set) time and temperature (Sections C, E, and F), it also indicates any malfunctioning of the heater. The heater has been in operation continuously for a period of 49 hours and has turned itself off automatically. In case of any malfunctioning the information display will tell you what is the matter. This heater is fitted with a safety system that ensures that it switches off automatically after 49 hours continuous operation. If desired, you can switch the heater on again by pressing When te heater has been burning continuously for two hours at its highest setting, the burner will automatically start an autoclean procedure. the display will show the autocleaningcode cl:05 running back to cl:00. The procedure takes 5 minutes, during which the heater will burn at its lowest setting, while the burner autocleans. When the burner is clean again, the heater will automatically switch back to the highest setting again. The childproof lock can be used to prevent children accidentally changing the heater settings. When the heater is burning and the childproof lock is on, the heater can only be switched off. If the heater has already been switched off, the childproof lock also prevents accidental ignition of the heater. [. . . ] If there is still some fuel left, do not throw it away, but dispose of it in accordance with the local regulations for the disposal of domestic chemical waste. When you start re-using the heater follow the instructions again (starting from section A and as specified). Take the following measures to avoid fuel leakage during the transportation of the heater: 1 Let the heater cool down. Your heater comes with a 24-month warranty starting on the date of purchase. [. . . ]