User manual PVG SRE 30X

[. . . ] Store all fuel containers with their original caps and seals in a cool and dark place. The use of Zibro Extra, Zibro Kristal or Zibro Bio as a heating fuel assures you that you have a good quality fuel. Before changing brands and/or types of fuel make sure that the mobile heater first completely empties all of the remaining fuel inside the heater. 4 40 WHAT YOU NEED TO KNOW IN ADVANCE VENTILATE SUFFICIENTLY Regardless of the model, you must always make sure that the heater is used in a room large enough to enable the heater to be used safely without extra ventilation. If the room is smaller than required, you must always open a door or window slightly (ensuring an opening of approx. [. . . ] To start the "QUICK IGNI. " function press the SETTING THE REQUIRED TEMPERATURE The temperature setting can only be adjusted when the heater is burning. The desired temperature is stored in the memory and remains after a restart or power failure. G USING THE TIMER The timer allows you to activate the heater at a certain time. In order to use the timer, the correct actual time must have been set (refer to section C). To set the timer: Press the mode button twice and the word TIMER will appear on the display. Use the buttons + and to set the time at which the heater has to start. The TIMER lamp switches on and the heater is ready to start at the desired time. H SWITCHING OFF THE HEATER Press the button. The green lamp inside the button will switch off and the heater stops within approximately 1 minute. A little white smoke and smell during the extinguish period is normal. I SAVE MODE In the save mode the heater will switch off when the room temperature, as sensed by the heater, rises 3C above the set temperature. The lamp in the button will switch on and the heater will now switch off when the room temperature rises 3C above the set temperature. The heater will start again when the room temperature drops below the set temperature. The save mode can be cancelled by pushing the SAVE button again, the lamp switches off. J THE INFORMATION DISPLAY The information display not only serves as an indicator of the (set) time and temperature, it also indicates any malfunctioning of the heater. The code on the information display tells you what is the matter: CODE CAUSES No flame during ignition. Use correct fuel (see section "The right fuel"). e- 0 e- 1 Flame sensor failure Check fuel, restart the heater. Use correct fuel (see section "The right fuel"). e- 2 No flame after ignition. Check fuel, restart the heater. Use correct fuel (see section "The right fuel"). e- 4 Poor flame during normal burning. Use correct fuel (see section "The right fuel"). e- 5 e- 6 e- 7 e- 9 e-A e-H KL FUEL TIME TIMER Ignition temperature too low. Ignition temperature too high. Disconnected the mains plug and restart. Cool down, disconnect the mains plug and restart. Wrong blower speed. The heater shows the actual time The heater shows the set time for timer The heater has been operating Disconnect the mains plug and restart. Push the and + buttons to adjust the set time when the heater has to start. Switch the heater on again. continuously for a period of 48 hours and has switched itself off (refer to section K). Remove the air filter occasionally and clean it with soapy water or with a vacuum cleaner. [. . . ] Children should be supervised to ensure that they do not play with the appliance. Waste electrical products should not be disposed with household waste. Check with your local authority or retailer for recycling advice. 4 49 DISTRIBUTED IN EUROPE BY PVG INTERNATIONAL BV i STERREICH PVG Austria VertriebsgmbH Salaberg 49 3350 HAAG tel: +43 7434 44867 fax: +43 7434 44868 email: pvgaustria@zibro. com e BELGI PVG Belgium NV/SA Industrielaan 55 2900 SCHOTEN tel: +32 3 326 39 39 fax: +32 3 326 26 39 email: pvgbelgium@zibro. com q SCHWEIZ PVG Schweiz AG Salinenstrasse 63 4133 PRATTELN +41 61 337 26 51 tel: fax: +41 61 337 26 78 email: pvgint@zibro. com 2 DEUTSCHLAND PVG Deutschland GmbH Siemensstrasse 31 47533 KLEVE 0800 - 9427646 tel: fax: +31 (0)412 648 385 email: pvgdeutschland@zibro. com 6 DANMARK Appliance A/S Gefionsvej 7 DK-3400 HILLERD tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group. com 5 ESPAA PVG Espaa S. A. San Jos de Valderas II Comunidad "La Alameda" C/ Aurora Boreal, 19 28918 LEGANS (Madrid) tel: +34 91 611 31 13 fax: +34 91 612 73 04 email: pvgspain@zibro. com 3 FRANCE PVG France SARL 4, Rue Jean Siblius B. P. 185 76410 SOTTEVILLE SOUS LE VAL tel: +33 2 32 96 07 47 fax: +33 0 820 34 64 84 email: pvgfrance@zibro. com SUOMI Appliance A/S Gefionsvej 7 DK-3400 HILLERD tel: +45 70 205 701 fax: +45 70 208 701 email: appliance@appliance-group. com FIN 4 UNITED KINGDOM Scott Brothers Ltd. [. . . ]