User manual REMINGTON 6250

[. . . ] 9 Do not twist or kink the cable and don?t wrap it around the appliance. Do not put the appliance in liquid; do not use it near water in a bath tub, basin or other vessel; and don?t use it outdoors. Do not reach for your unit if it has fallen into water - immediately unplug it from the electrical outlet. 13 This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. [. . . ] In order to determine if you can use i-LIGHT, perform a test on a small patch of skin and wait 24 hours to determine if there are any adverse reactions before treating more broadly. Hormonal changes are common during pregnancy or breast-feeding and could increase skin sensitivity and the risk of skin injury. ? DO NOT treat any area where you may someday want your hair to grow back. ? If you?ve had professional or clinical or self-administered laser or IPL or electrolysis hair removal treatments, wait at least 6 months before using i-LIGHT. If you?ve waxed, plucked or epilated hair in the treatment area, wait at least 6 weeks before using i-LIGHT. The device uses the hair under your skin to disable your hair at the root, so it is not effective if the hair has been pulled out. ? DO NOT use directly over or near Active Implantable Medical Devices such as implantable pacemaker, internal defibrillator, or insulin devices. Although no problems associated with the use of this device have been reported during clinical studies, it is recommended to observe all active implantable medical device warnings regarding the use of electronic devices to prevent any failure or interruption of an active implantable device. 8 ENGLISH GB C PREPARING FOR USE , Familiarise yourself with the features of your new i-LIGHT device. , Flash Window with built-in UV skin protection ? WARNING: always inspect the Flash Window before use to ensure there is no damage to the lens. ? WARNING: always clean the Flash Window before use with the lint-free cloth provided to ensure there is no oil or debris on the lens. If the skin appears normal, proceed with your first full treatment at the energy level you determined is right for you. , NOTE: You must test the device on each area of the body you wish to treat. C TREATMENT ? Multi-Flash Mode: The i-LIGHT device will flash when the Flash Button is pressed and will continue to flash every 3 seconds when the skin contact sensors are fully engaged. The Multi-Flash mode allows you to quickly treat large areas by simply gliding the hand piece over the skin after each flash. , How to treat: ? Place the Flash Window firmly against the skin - ensure the Skin Contact Sensors are fully engaged. , NOTE: When the Skin Contact Sensors are fully engaged you will hear a ?chirp?You should expect to see a bright flash of light (similar to a camera flash), and you should feel a mild sensation of warmth. 3 Move to the next area and treat in a grid like pattern to ensure full coverage of the treatment area. ? For Single-Flash Mode, press the Flash Button each time you move to the next area. ? For Multi-Flash Mode, keep your finger on the Flash Button to keep it depressed and glide to the next area being sure to keep the Skin Contact Sensors fully engaged. , Signs that the bulb needs replacing: ? Bulb Status Indicator is illuminated yellow: 150 Flashes remain in the bulb ? Bulb status indicator is flashing yellow: Bulb is empty. [. . . ] all currently selected energy level indicators flashing Unit is overheated and is disabled momentarily to cool down. All LED?s flashing with warning beep Treatment head is removed or loose. 15 SK P FIN S LED?s All energy level indicators flashing Unit is malfunctioning. Flash button was pressed while the skin contact sensor was not fully engaged. [. . . ]