User manual REMINGTON AQ7

[. . . ] KEY FEATURES 4 9 1 On/off switch 2 Head & Cutter assembly 3 Individual flexing heads 4 Head release button 5 Hairpocket 6 Charging indicator light 7 Charging stand 8 Charging pins 9 Cleaning brush 10 Adaptor • 2 year guarantee GETTING STARTED 8 6 • • • • • • 10 For best shaving performance, it is recommended that you use your new shaver daily for up to four weeks to allow time for your beard and skin to become accustomed to the new shaving system. Connect the shaver to the adapter, then to the mains and charge for at least 24 hours when using for the first time. After the shaver is fully charged, the blue indicator light will glow steadily. [. . . ] The easiest and the most hygienic way to clean the appliance is by rinsing the product head after use with warm water. € • • • • • • IMPORTANT SAFETY INSTRUCTIONS WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: • An appliance should never be left unattended when plugged in to a power outlet, except when charging. SERVICE AND GUARANTEE This product has been checked and is free of defects. We guarantee this product against any defects that are due to faulty material or workmanship for the guarantee period from the original date of consumer purchase. If the product should become defective within the guarantee period, we will repair any such defect or elect to replace the product or any part of it without charge, provided there is proof of purchase. 4 AE HR/ SRB SL GR MONTHLY Perform the daily cleaning steps first. Open the shaver head by pressing the release button on the front of the shaver and flipping open the head away from the body of the shaver. Release the inner cutter carrier by rotating the locking arms counter-clockwise. Thoroughly brush hairs from the inner and outer cutters and rinse out remaining debris. Place the inner cutter carrier back onto the upper hairpocket and lock in place by rotating the locking arms clockwise until the arms ‘click’ into place. This shaver is a wet shaver, the hand-held part of which may be used in a bath or shower. BATTERY REMOVAL • • • • • • • • The battery must be removed from the appliance before it is scraped. The appliance must be disconnected from the supply mains when removing the battery. Using screwdriver remove (6) screws from front of shaver, and remove the rear housing. Cut or break the wire stamps on both ends of the battery and remove the battery. Open the shaver head by pressing the release button on the front of the shaver. [. . . ] oPLADNING AF DIN BARBERMASKINE • • • • • • Sluk for apparatet. Forbind barbermaskinen til adapteren, derefter til stikkontakten og lad den oplade i mindst 24 timer, forud for at den bruges for første gang. Hvis der skulle opstå en defekt i forbindelse med produktet, inden for garantiperioden, vil vi reparere enhver sådan defekt, eller vælge at erstatte produktet eller dele heraf uden gebyr, såfremt der foreligger bevis for køb. [. . . ]